Airbot Omnibus F4 Flight Control - Betaflight 3 with OSD and Barometer

Semua produk di etalase DOoFPV ready stock, bisa langsung dipesan. Proses kirim harian tiap Senin-Jumat jam 3 sore. ============================================================ OMNIBUS AIO F4 V6 Flight Control - 5xUARTs - ORIGINAL AIRBOT , bukan CLONE Versi Omnibus F4 OSD V6 dengan sensor BAROMETER on board. Siap flash ke Betaflight , Butterflight atau INAV Original AIRBOT - DOoFPV adalah partner Airbot, jadi jaminan untuk dapatkan yang original di DOoFPV. Perhatikan target firmware karena ini versi baru, selengkapnya bisa baca di Online Guide: https://blog.dronetrest.com/omnibus-f4-v6-flight-controller-guide/ New firmware target: OMNIBUSF4FW (in BetaFlight) / FIREWORKS V2 (in iNav) #39; #39; #34; for Betaflight, after flashing, go to CLI and type (without quotations): #39; #39; #34;set gyro_to_use = second #39; #39; #39; , and save to get the IMU working. The IMU roll offset needs to be set to 180 degrees. New features: - New soldering point pads instead of through hole connectors. Larger pads for ground and power. - 5x UART Ports - 5V 1A and 8V BEC for FPV camera - Current source jumper selector OMNIBUS F4 #39;s upgrade version, using F405 and new target with 5x UARTs now. New OMNIBUS design, using F4 MCU controls OSD over SPI bus, compare the first version, we added BMP280 as barometer and SD Card supports. OSD Configuration has been incl. in Betaflight GUI. FC incl. 5V1A BEC on board(3-6s) and 1x 8V BEC for Camera MPU6000 at SPI bus, Ext, SPI for damped gyro New version with 8PIN Sh1.0 Socket, could be much easier connect to our 4in1 ESC by one cable. On v5, we added jumpers for Current source select, please read the manual and set the jumper before using the FC. Features: STM32 F405 MCU SBUS/PPM input (Pinheaders) 6PWM output (1-4Pinheaders and Sh1.0 Plug, 5-6 as Pinheaders) Only 36x36mm, mount holes 30.5x30.5mm INCL. BARO BMP280 SPI Sensor MPU6000 Flash Package incl.: 1x FC