Modul Relay 24V Hi-Lo Input Optocoupler - Relay, 1 Channel

Deskripsi Modul Relay Channel 24V Hi-Lo Input Optocoupler

- 1 channel relay module
NO & NC Pin Maximum load: AC 250V/10A, DC 30V/10A
Using OPTOCOUPLER isolation, the trigger current only 5mA
The module have 24V DC Coil
The module can be set to high or low triggered by jumper
Fault-tolerant design, even if the control line is broken, the relay will maintain;
Has the power indicator (green) and relay status indicator (red)
Size: 50*26*18.5mm
Has four mounting bolts holes, hole 3.1mm, 44.5*20.5mm pitch
Interface:
Input:
VCC: Relay power supply +
GND: Relay power supply -
IN: Signal trigger input (High or Low Level Signal, select via jumper)
Output:
NO: Relay normally open.
COM: Relay Common Pin
NC: Relay normally closed.

- 2 channel relay module
1. Beban maksimum: AC 250V/10A, DC30V/10A
2. Mneggunakan komponen SMD sehingga hemat daya dan optocoupler agar kinerja stabil
3. Tegangan kerja : DC 24V
4. Setiap channel modul dapat diatur tinggi atau rendah pemicunya dengan mengubah jumper
5. fault-tolerant, jika garis kontrol rusak, relay tidak akan beroperasi
6. Indikator daya (hijau), 2 relay state indikator (merah)
7. Desain antarmuka user-friendly, semua antarmuka melalui kabel terminal koneksi langsung
Modul Port:
1. DC +: DC 24V power supply positif
2. DC: DC power supply negatif
3. IN1: Terminal Saluran 1 sinyal pemicu
4. IN2: Terminal Saluran 2 sinyal pemicu
Relay Output:
1. NC1: Channel 1 relay normally close.
2. COM1: Channel 1 relay sumber input.
3. NO1: Channel 1 relay normally open.
4. NC2: Channel 2 relay normally close.
5. COM2: Channel 2 relay sumber input.
6. NO2: Channel 2 relay normally open.
Pengaturan trigger tinggi dan Rendah:
1. S1: Pilihan trigger untuk saluran 1
2. S2: Pilihan trigger untuk saluran 2

- 4 channel relay module
Configureable Activation Logic, High or Low, via mini jumper
Maximum Current Rating: 10A
Maximum Voltage Rating: AC 250V
Can control various appliances with large current and high voltage
Can be controlled directly by microcontroller such as Arduino, 8051, AVR, PIC, DSP and ARM
Build in an Opto-Isolator for extra isolation and protection to controller.
A power indicator LED, Green
Comes with an indicator LED