*Module breakable, PCB bisa dipisah tiap tombol *Menggunakan push button besar 12x12mm *Tombol dilengkapi Cap/knop 5 warna berbeda *Tombol sudah dipasang di PCB dan dilengkapi pin header *Support kabel jumper Dupont ke Breadboard atau ke Board Development (Arduinoo/ESP/STM/Raspberry dll.) *Sudah dilengkapi resistor Pull-down 10K onboard.
Spesifikasi : Ukuran tombol : 12x12 mm (standar Omron) Ukuran PCB : 14x22 mm / pcs Cap size : *diameter bawah : 12.8mm *diameter atas : 11.4mm *tinggi cap : 5.5mm Tegangan kerja : 3.3v ~ 5V DC Pinout : V (VCC) : DC+ 3.3V/5V G (GND) : DC- / Ground 0V S (SIGNAL) : Output Active High
Kondisi tidak ditekan Output S=LOW (Pull-down 10K ke GND) Kondisi tombol ditekan Output S=High (terhubung ke VCC)
*untuk pin input di MCU/Arduino disetting sebagai INPUT biasa (High active) bukan INPUT_PULLUP (Low Active)