Mq-135 Module Air Quality Sensor Detects Harmful Gases arduino

(Local Stock) Mq-135 Module Air Quality Sensor Detects Harmful Gases arduino raspberry mq135

MQ135 Spec:
Detection of gas: Ammonia /Sulfide/ Benzene vapor
Detection of Concentration:10-1000ppm
Input voltage: DC 5V
Power consumption (current): 150mA
AO output: 0.1-0.3V (relatively non-polluting), the highest concentration voltage is about 4V

This is sensor module based on MQ135 gas sensor uses in clean air low conductivity tin oxide (SnO2). It comes with basic components to enable the sensor to function properly and hook up easily to any controller that you preferred. When the sensor is kept in their environment, the conductivity in the sensor increases with the air pollution in gas concentration increases.

For Arduino, connect DO to any digital pin (if you want it in digital input). Connect AO at analog pin (if you want it in analog input).

Features:
Wide detecting scope
Fast response and High sensitivity
Stable and long life
Operating Voltage is +5VDC
Detect/Measure NH3, NOx, alcohol, Benzene, smoke, CO2, etc.
Analog output voltage: 0V to 5V
Digital output voltage: 0V or 5V (TTL Logic)
Preheat duration 20 seconds
Can be used as a digital or analog sensor
The Sensitivity of digital output can be adjusted using on board potentiometer
The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module)
The voltage of the analog output, the higher the concentration, the higher the voltage.
Arduino compatible
Comes with 4 mounting screw holes (M3 or 3mm size)
Product dimensions: 32 (L) * 20 (W) * 22 (H)


Note: After the sensor is energized, it needs to be preheated for about 20S, and the measured data is stable. The heating of the sensor is a normal phenomenon, because there is a heating wire inside.

Packing List:
1 xMQ135 Air Quality Sensor Module