Prusa MK4 XL Replacement Thermistor - 104NT 100K High Temperature Sensor 2Pin

Prusa MK4 XL Replacement Thermistor - 104NT 100K High Temperature Sensor 2Pin
Drop in replacement 3D printing project: replace the stock Nextruder heaterblock temperature sensors, only compatible with newest prussa MK4 MK3.9 XL, not compatible old version MK52 MK3S MK3 MK2.5S MK2.5 MK2S MMU2S CW1 SL1 MINI MK3S+ MINI+ SL1S CW1S MK2 MMU2 MMU1 MMU3. This version Thermistor Line Length about 115mm, total length 135mm, long enough for PrusaXL 3D printer heating block
Spare part for the stock cartridge thermistor: 104NT sensor, the 104GT-2 thermistor's upgrade, 304 stainless steel cover the internal temperature package, about 90mm Wire, with 2pin MX connector, Temperature measurement head cylinder diameter 3mm, length 8mm, the total length is about 122mm/4.8inch,can be used with the same size like v6 heating block that support the thermocouple
Ease of use: it is a great replacement for a broken thermistor, locks onto the board connector. The Customized Terminal Connector is specially for MK4 - XL - MK3.9 loveboards, so please check before ordering
Great temperature match: The temperature measurement: -50 °C ~ +300 °C for a long lifecycle, sometimes can reach up to +300℃ for a short time using, can replace the v6 hot end K-type thermocouple temperature, very fit for printing high-temperature filament ABS ASA PETG (Please note that the temperature should not be over 300 °C, otherwise the temperature will not be accurate)