Keterangan : Type C USB tersolder, Micro USB belum tersolder
The Raspberry Pi Pico is a microcontroller board based on the Raspberry Pi RP2040 microcontroller chip. It has been designed to be a low-cost, high-performance microcontroller board with flexible digital interfaces. The Raspberry Pi Pico features two ARM Cortex-M0+ cores run up to 133MHz; 256KB RAM; 30 GPIO pins; and a broad range of interfacing options. This is paired with 2MB of onboard QSPI Flash memory for code and data storage.
In addition to powerful hardware resources, Pico has rich and complete software support and community resources. It comes with a complete Rasberry Pi official C/C++ SDK, Micropython SDK. Just click pico.raspberrypi,org/getting-started" to get started with Raspberry Pi Pico.
Pico has been designed to use either soldered 0.1" pin-headers (it is one 0.1" pitch wider than a standard 40-pin DIP package) or can be used as a surface-mountable 'module', as the user IO pins are also castellated. There are SMT pads underneath the USB connector and BOOTSEL button, which allow these signals to be accessed if used as a reflow soldered SMT module.
Spesifications : - 21 mm 51 mm form factor - RP2040 microcontroller chip designed by Raspberry Pi in the UK - Dual-core Arm Cortex-M0+ processor, flexible clock running up to 133 MHz - 264KB on-chip SRAM - 2MB on-board QSPI Flash - 26 multifunction GPIO pins, including 3 analogue inputs - 2 UART, 2 SPI controllers, 2 I2C controllers, 16 PWM channels - 1 USB 1.1 controller and PHY, with host and device support - 8 Programmable I/O (PIO) state machines for custom peripheral support - Supported input power 1.85.5V DC - Operating temperature -20C to +85C - Castellated module allows soldering direct to carrier boards - Drag-and-drop programming using mass storage over USB - Low-power sleep and dormant modes - Accurate on-chip clock - Temperature sensor - Accelerated integer and floating-point libraries on-chip