MOTOR DRIVER SHIELD L293 L293D

Hi, Teknokers. Selamat berbelanja :) Deskripsi: ================================= Merupakan shield yang berfungsi untuk men-drive motor. Shield ini bisa men-drive baik motor DC, stepper dan servo gan. Berikut fitur lengkapnya : Features: ================================= - Brand new and high quality. - L293D is a monolithic integrated, high voltage, high current, 4-channel driver. - Basically this means using this chip you can use DC motors and power supplies of up to 10 Volts, thats some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also whats known as a type of H-Bridge. - The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor. - 2 interface for 5V Servo connected to the Arduino #39;s high-resolution dedicated timer - no jitter. - Can drive 4 DC motors or 2 stepper motors or 2 Servo. - Up to 4 bi-directional DC motors with individual 8-bit speed selection. - Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping. - 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 10V DC. - Pull down resistors keep motors disabled during power-up. - reset button. - 2 external terminal power interface, for seperate logic/motor supplies. - Tested compatible for Arduino Mega, Diecimila amp; Duemilanove. - Size:6.8cm x 5.5cm x 2cm - 2.68inch x 2.17inch x 0.79inch.