Bgc3.1 2-Axis Brushless Gimbal Driver Alexmos Controller Mulicopter

Introduction: The current version of the controller is version 3.1,They normaly come with the bootloader on the chip and you just need to upload the firmware via micro USB. Features: Brand new and high quality Brushless gimbal controller 3.1 Micro USB connector (no FTDI needed) Stabilized VBUS (USB port) Pin layout optimized GND, A1 and A2 GND, multi-port, 5V L6234 brushless motor driver 2 outputs for brushless motors 4 receiver inputs 6 analog inputs Serial port available Power LED (blue) Small LEDs on the USB Dimensions: 50 mm x 50 mm Standard MK style mounting holes 45 mm x 45 mm 2 instead of 4 glass diodes SOT23 5V better stabilized Shifter lever on the I2C Bus (3.3V to 5V) Pull reduced (for better edges) MPU6050 3 sensor module Chip: MPU-6050 Power supply: 3-5V (internal chip), 10-15V external board input voltage. Gyroscope range: + 250 500 1000 2000 / s Acceleration range: 2 4 8 16 g Communication: Standard IIC communication agreement Chip built-in 16 bit AD converter, 16 bits of data output Pin pitch: 2.54mm Size: 20.3mm x 16.5mm Isi Paket: 1 x Brushless Gimbal Controller 3.1 1 x MPU6050 Sensor 1 x Cable