4.7/ 5.0
100% pembeli merasa puas
3 rating • 1 ulasan
5(2)66.67%
4(1)33.33%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 9984
Subtotal
Rp50.000
PL2303 USB to UART TTL Cable
Rp50.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: All
# Mohon baca KEBIJAKAN TOKO semut-tekno | ORDERAN diatas jam 06.00 pagi dikirim
BESOK | Informasikan Kalau barang ingin dilakukan pengecekan karena TIDAK
BERGARANSI !!! #
STOCK UPDATE : 27pcs
Line sequence defined Red 5V, Black GND, Green TxD, White RxD
Pin Connection & Description :
The wrong connection be sure to find the pin definitions, especially GND must
not be connected to the voltage on the pin, and the RX and TX terminal is not
connected to the VCC pin (actual measurement of some VCC pin voltage up to 14V.)
shall be burnt adapter cable chip, certain note, do not take their own small
plate to experiment, or burn We are not responsible. Must find the pin
definitions in the next.
Connection Method :
Repeat Brush only need three lines, generally used in the RX TX GND three signal
lines, the VCC without access. The above 4,5 needle friend, not connected to VCC
and BT needle. Use RXD connected with the target board TX phase, TXD and target
board RX, GND connected to GND if not, swap RX and TX
BESOK | Informasikan Kalau barang ingin dilakukan pengecekan karena TIDAK
BERGARANSI !!! #
STOCK UPDATE : 27pcs
Line sequence defined Red 5V, Black GND, Green TxD, White RxD
Pin Connection & Description :
The wrong connection be sure to find the pin definitions, especially GND must
not be connected to the voltage on the pin, and the RX and TX terminal is not
connected to the VCC pin (actual measurement of some VCC pin voltage up to 14V.)
shall be burnt adapter cable chip, certain note, do not take their own small
plate to experiment, or burn We are not responsible. Must find the pin
definitions in the next.
Connection Method :
Repeat Brush only need three lines, generally used in the RX TX GND three signal
lines, the VCC without access. The above 4,5 needle friend, not connected to VCC
and BT needle. Use RXD connected with the target board TX phase, TXD and target
board RX, GND connected to GND if not, swap RX and TX
Ada masalah dengan produk ini?