Diymore DC 6V-60V 400W BLDC 3 Fase PWM Hall Motor Controller Brushless

About Product: 1.MA MB MC phase output connection motor 2. 5V GND motherboard comes with 5V power supply (current does not exceed 30MA) 3.VCC GND motor main power supply (external DC power supply) 4.SC speed pulse signal output 5 positive and negative reversing control interface (also can be connected to the external switch) 6.VR speed control signal input (onboard with potentiometer speed control can also be connected to 0-5V analog simulation PWM duty cycle to support dual signal input speed regulation) 7.Ha Hb Hc +5V GND Hall signal Power input, generally with Hall #39;s motor has five corresponding s Full patch process Stable performance with positive/reverse function Tips: After receiving the goods, there are generally 5 Hall wiring s on the brushless motor. Two of them are the Hall power supply s. The three Hall signal s must be distinguished. Especially, the power supply s must not be mistaken. The sequence on the board must match the sequence of the three phase s on the motor driver board to work properly. If you do not know the definition of the Hall wire, you can debug the low voltage and current at the first power on. Change the order of the Hall until normal operation, do not use large current, high voltage debugging, if the Hall is not connected in sequence, the high voltage and high current test machine, there is the risk of damage to the MOS tube, if the three Hall signal s The motor is running smoothly and smoothly. The low-speed start is stable and the torque is large. If the three Hall signal s are not connected, the following characteristics are available: 1 The motor cannot be started normally or the start-up is difficult (sometimes it is necessary to manually turn the motor to start) 2 The motor starts to shake with no power.   Model Number: ZS-X11D1 Operating voltage: 9-60V Maximum current: rated 16A peak 20A Maximum power: 450W Overcurrent prot SKU : 3131/1333761716801454080/55