L298P Shield Driver H-Bridge Pengontrol Kecepatan PWM Motor

NOTE :
-SETIAP PEMBELIAN DIATAS 200 RIBU, GRATIS 1 BUAH CD BERISI BANYAK PROJECT UNTUK PRAKTIKUM LENGKAP DENGAN SOURCODE DAN SKEMATIK NYA.
-DAN MASIH BANYAK LAGI MODUL PRAKTIKUM LAINNYA.
-MODUL PRAKTIKUM AKAN DIKIRIM VIA EMAIL, JIKA MEMESAN SERTAKAN EMAIL.
sangat cocok untuk yang ingin belajar.

L298P Shield Driver H-Bridge Pengontrol Kecepatan PWM Motor Dual High Power

L298P PWM Speed Controller Dual High-Power H-bridge Driver ,Bluetooth Interface, L298P Motor Shield Board for Arduino

Deskripsi Produk
L298P Shield DC motor drives using LGS's outstanding high-power motor driver chip dedicated L298P, can directly drive two DC motors, drive current up to 2A, motor output using eight-speed Schottky diodes as protection. Stack design can be directly plugged into the Arduino, easier to use!
Board Dimension : 7.0 x 5.4 x 2.4 cm
The L298 Stepper Controller makes it easy to drive either two DC motors or a bipolar stepper motor.
Double H bridge drive
Chip L298P (SMD type)
Logical voltage 5V
Drive voltage 5V-35V
Logic current 0mA-36mA
Drive current 2A (MAX single bridge)
Storage temperature -20 to +135
Max power 25W
Logical part of the input voltage Vd: 5Volt DC
Driven part of the input voltage Vs: Vin/ Input 6.5 ~ 12Volt DC,
Motor Power / PWRIN 4.8 ~ 35Volt DC
Logical part of the work current Iss : 36mA
Driven part of the operating current Io : 2A
Maximum power dissipation: 25W (T = 75 Celsius)
Control signal input level: High 2.3V -0.3V
Working temperature: -25 + 130 Celsius
Hardware interface: 5.0mm pitch screw terminal
Belt clip and can be controlled via front row access signal