Modul Sensor Getar

NOTE :
-SETIAP PEMBELIAN DIATAS 200 RIBU, GRATIS 1 BUAH CD BERISI BANYAK PROJECT UNTUK PRAKTIKUM LENGKAP DENGAN SOURCODE DAN SKEMATIK NYA.
-DAN MASIH BANYAK LAGI MODUL PRAKTIKUM LAINNYA.
-MODUL PRAKTIKUM AKAN DIKIRIM VIA EMAIL, JIKA MEMESAN SERTAKAN EMAIL.
sangat cocok untuk yang ingin belajar.

Deskripsi Produk
Normally Open SW-18015P Sho Sensor Module Vibration Sensor Module Alarm Module Board
Feature:
1. Used for various vibration triggering, alarm, intelligent car, electronic building blos and so on.
2. Please note that the triggering time of this module is very short when it senses small vibration, and it is not enough to drive the relay. Some people's data show that it can be directly connected with the relay module, and the actual application effect is not good.
3. All kinds of sensitive vibration switches produced by our company are adopted, and SW-18015P vibration sensor is used by default.
4. Comparator output, with clean signal, good waveform, strong driving ability, more than 15A.
5. Fixed bolt hole for easy installation.
6. Using a Wide Voltage LM393 Comparator.

Specification:
Working voltage 3.3V-5V
Output Form: Digital Switch Output (0 and 1)
PCB Size of Small Plate: 32mm*17mm*5mm/1.25*0.66*0.19''
Paing weight: 2g

Module Interface Description (3-wire):
1. VCC external connected to 3.3V-5V voltage (can be directly connected with 5V MCU and 3.3V MCU).
2. GND external connected to GND.
3. DO board digital output interface (0 and 1).

Operation Manual:
1. Connect VCC and GND, module power indicator will be on.
2. Place the module lightly on the desktop, adjust the blue potentiometer on the board until the switch indicator lights on the board, then slightly adjust the potentiometer, let the switch indicator lights off, and then tap the desktop with your hand to make the vibration sensor have a sense of vibration.
3. At this time, the switch indicator lights will be on again. When the vibration stops, the switch indicator will also go out. This phenomenon