5.0/ 5.0
100% pembeli merasa puas
3 rating • 0 ulasan
5(3)100%
4(0)0%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 24
Subtotal
Rp176.700
Raspberry Pi Camera 5MP OV5647 Lensa Wide Angle +IR Night Vision Light
Rp176.700
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Aksesoris Arduino
Camera OV5647 Wide angle + 2x IR Night Vision Led Light
Introduction :
This is the fish eye lens camera module for Raspberry Pi. The angle of lens is 130 degree and focal can be adjusted.
Feature:
1. Fish eye wide angle 130 degree lens
2. 5 MP pixel
3. Support 1080P resolution
Specifications:
1. 5 megapixelOV5647 sensor
2. CCD size : 1/4inch
3. Sensor best resolution : 1080p
4. 4 screw holes:used for attachment ,connect 3.3V power output
5. Focal length : 2.1
6. Diagonal angle : 220 degree
7. Dimension: 25mm x 24mm
How to use Raspberry Pi Camera
1. Install Raspbian system into SD card and insert to Raspberry Pi, connect the display to Raspberry Pi, Connect the camera to Raspberry Pi correctly.
2. Open the terminal and run
sudo raspi-config
3. Choose the Interface--Enable Camera , enter it , then it the Raspberry Pi will restart automatically ( if not , you can restart it by yourself)
Open the terminal again , run
raspistill t 5000 o test.jpg
then the camera will be on.The 5000means the camera will open 5 seconds , the test is the name of picture , you can change them as your need.
Package list :
1 x Fisheye Camera
2 x LED IR Night Vision
1 x 15 cm Flate Cable
RAJACELL BEKASI
Introduction :
This is the fish eye lens camera module for Raspberry Pi. The angle of lens is 130 degree and focal can be adjusted.
Feature:
1. Fish eye wide angle 130 degree lens
2. 5 MP pixel
3. Support 1080P resolution
Specifications:
1. 5 megapixelOV5647 sensor
2. CCD size : 1/4inch
3. Sensor best resolution : 1080p
4. 4 screw holes:used for attachment ,connect 3.3V power output
5. Focal length : 2.1
6. Diagonal angle : 220 degree
7. Dimension: 25mm x 24mm
How to use Raspberry Pi Camera
1. Install Raspbian system into SD card and insert to Raspberry Pi, connect the display to Raspberry Pi, Connect the camera to Raspberry Pi correctly.
2. Open the terminal and run
sudo raspi-config
3. Choose the Interface--Enable Camera , enter it , then it the Raspberry Pi will restart automatically ( if not , you can restart it by yourself)
Open the terminal again , run
raspistill t 5000 o test.jpg
then the camera will be on.The 5000means the camera will open 5 seconds , the test is the name of picture , you can change them as your need.
Package list :
1 x Fisheye Camera
2 x LED IR Night Vision
1 x 15 cm Flate Cable
RAJACELL BEKASI
Ada masalah dengan produk ini?
ULASAN PEMBELI
Belum ada ulasan untuk produk ini
Beli produk ini dan jadilah yang pertama memberikan ulasan