Clippy Xlr Em272Z1 Matched Stereo Pair - Down Payment

Barang Preorder silahkan chat sebelum membeli :) The manual can be downloaded at the bottom of this page. The Clippy EM272 XLR uses the acclaimed Primo EM272Z1 capsule, made in Japan. This capsule is extremely low noise (typical 14 dBA self noise) and high sensitivity (-28 dB). Our own unique electronic design provides a regulated 8 volts to the capsule whether the unit is powered from 12, 24 or 48 volt phantom 1.5 m fully screened flexible but strong Mogami cable NEUTRIK black metal XLR with gold plated pins A pair of Clippy Clips Type B included 12 volt operation to help increase battery life on portable recorders. Available as stereo pairs with matched sensitivity The EM272 capsule is used extensively by ASMR artists where it #39;s low noise and high sensitivity make it really shine. Specifications: Microphone Capsule: Primo EM272Z1 Acoustic Principle: Pressure operated Directional Pattern: Omni directional Frequency Range: 20 Hz to 20 kHz Signal to Noise Ratio: 80 dB at 1 kHz Self Noise: 14 dB-A Clipping SPL: 120 dB SPL at 1 kHz Sensitivity: -28 dB +/- 3dB at 1 kHz (0 dB = 1V/Pa) Dynamic Range: 105 dB-A Output Impedance: 1.4 k ohms Power Requirement: Phantom power, 12-48V Current Consumption: 0.9 mA Cable: 1.5 metres, Shielded balanced Mogami 2697 cable Output Connector: XLR Male, Neutrik, gold plated pins Microphone enclosure Dimensions : 11.8 mm x 25 mm Weight: 49g (1.7 oz), per microphone There is a small family of Clippy EM272Z1 microphones as below: With 3.5 mm plugs, requiring Plug-in Power: Mono Clippy - with straight stereo moulded plug, the mic signal is fed to both left and right channels Stereo Clippy - with right angle stereo metal plug - a Matched Pair of Clippy mics Stere Module - with straight stereo moulded plug - a Matched Pair of Clippy mics Stere Module - with right angle stereo metal plug moulded - a Matched Pair of Clippy mics Smart Mono Clippy - with straight TRRS moulded plug suitable for use with mobile phones and some laptop computers. With XLR plugs and requiring phantom power: Mono - a single mono Clippy microphone with a 3 pin male XLR Stereo - pair of matched XLR Clippy mics, each with a 3 pin male XLR Quad - 4 matched XLR Clippy mics, each with a 3 pin male XLR Say Hello to Binaural Bill. Bill uses our Clippy XLR mics to create great binaural recordings, you can read all about him here. #34;The Clippy XLR EM272Z1 is 6 dB more sensitive and 8 dB lower in noise than a DPA4060 for a fraction of the price, what #39;s not to like! #34; GH, London Plugging in these small and cheap microphones put a big grin on my face. Great build quality and very quiet when used with my Sound Devices mixer/recorder. Mats O, Sweden What #39;s in the box: 2 x Clippy XLR Microphones with Clips