Temperature & humidity sensor digital (With Stainless Steel Probe)SHT

This product is one of Sensirion’s family of surface-mountable relative humidity and temperature sensors. The SHT10 sensor includes a temperature/humidity sensor module in a sinter metal mesh encasing. The casing prevents water from reaching the sensor even when completely submerged, but it allows air to pass through for measuring temperature and humidity. It #39;s imperative, however, to limit submersions to 1 hour or less at a time. Due to the measured data are transmitted digitally, there is no signal degradation over long distances. The protocol used for data transmission is a Sensirion 2-Wire that compatible with I2C: #34;The sensor cannot be addressed by I2C protocol; however, the sensor can be connected to an I2C bus without interference with other devices connected to the bus. #34; A 10KΩ resistor needs to be connected between DATA and VCC as a pull-up, which increases the reliability of the communication between the microcontroller or single-board computer and this sensor. To start gathering data, you #39;ll need to make use of one of the SHT10 available libraries for your platform. Features: Input Voltage: 3V ~ 5V Output Type: Digital SHT ADC Res: 14 bit Temperature range: -40°C ~ 120°C Temperature accuracy: 0.5°C Humidity range: 0 ~ 100% RH Humidity accuracy: 4.5% RH Interface: I2C Size: 14mm x 50mm (D x H) Wiring: Red = VCC Black or Green = Ground Yellow = Clock Blue = Data Package Include: 1 x SHT10 Sensor