Memmert Waterbath WNB 14 rack

Temperature range in °C min. 5°C above ambient up to +95°C with additional boiling mode (+100°C)
Control of standard components
Temperature 1 Pt100 sensor class A in 4-wire-circuit
Timer integrated digital timer from 1 min. to 99,59 hours for: ON continuous operation WAIT (delayed on for continuous and limited timed operation) HOLD
Safety
Temperature control mechanical temperature limiter TB protection class 1 switching the heating off at approx. 30°C above max. temperature of the bath
Temperature control in case of overtemperature due to failure, the heating is switched off at approx. 10°C above the set temperature (fixed value)
Autodiagnostic system microprocessor PID-temperature controller with integrated autodiagnostic system with fault indicator
Heating concept
Heating Baths corrosion-proof large-area heating on three sides
Standard equipment
Controller digital display (LED) of set and actual temperature (0,1°C resolution) and of (remaining) programme time
Textured stainless steel casing
Dimensions w(D) x h(G) x d(E): 578 x 436 x 238 mm
Electrical data
Voltage 230 V, 50/60 Hz
Electrical load approx. 1800 W (during heating)
Ambient conditions
Installation The vent openings in the left and back side must remain unobstructed. Minimum wall spacing on all sides is 80 mm. The minimum spacing from the top of the bath to the next ceiling is 750 mm.
Ambient temperature +5 °C to +40 °C
Humidity rh max. 80 %, non-condensing