Atur jumlah dan catatan
Stok Total: 100
Subtotal
Rp590.000
Matek ELRS 2.4Ghz VARIO Receiver 7x PWM Output Baro Glider Fixed Wing
Rp590.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Semua Etalase
Specific for the Gliders and other fixed-wings. Small in form factor, It can be installed in gliders with restricted payload bays such as DLG’s and high performance slopers. Not needing to install an additional altimeter/variometer also saves room and weight.
The built in barometer provides vertical speed telemetry. The variometer sounds both ascending and descending tones, so you will know whether you are in lift or sink without having to look at your transmitter.
with ExpressLRS firmware and CRSF protocol, this will also give you other telemetry data like battery voltage, current and GPS related.
Specifications
ESP8285, SX1281, ExpressLRS Firmware
RF Frequency: 2.4GHz ISM (2400~2480MHz)
Antenna connector: IPEX MHF-1
Telemetry power: 12dbm
CRSF-PWM-V converter with barometer integrated
7x PWM outputs (6x with power rails, PWM8 is just a signal pad)
PWM frequency: 50, 100, 160, 330, 400Hz configurable
PWM resolution: 4x 1024 position + 3x 128 position(ExpressLRS 2.0 Wide switch mode)
1x UART(2) for GPS
36V Max. battery voltage sense (1K:10K voltage divider built-in)
Compatible with external Current sensor (0~3.3V)
RxBt,Curr,Capa,Bat%,GPS telemetry and VSpd(Vario)
Rated voltage: 3.5~9V @5V pad, 0~36V @Vbat, 0~3.3V @Curr
Power dissipation: 50mA(binding), 90mA(wifi mode)
No 5V regulator built-in, Servos must be powered via 5V pad on CRSF-PWM-V board by external 5V source.
Failsafe value configurable
Firmware upgradeable
Physical:
PCB Size: 27x16mm,
Weight: 5g w/ antenna and 2.54 pins
Packing:
1x ELRS-R24-V(includes CRSF-PWM-V and 2.4G Receiver)
1x IPEX MHF1 Antenna
2.54mm straight and 90° 3×6 Dupont pins
Firmwares
2.4GHz Receiver: ExpressLRS /DIY_2400_RX_ESP8285_SX1280, V2.0 or newer
CRSF-PWM-V: crsf_pwm_v2.0 or newer
The built in barometer provides vertical speed telemetry. The variometer sounds both ascending and descending tones, so you will know whether you are in lift or sink without having to look at your transmitter.
with ExpressLRS firmware and CRSF protocol, this will also give you other telemetry data like battery voltage, current and GPS related.
Specifications
ESP8285, SX1281, ExpressLRS Firmware
RF Frequency: 2.4GHz ISM (2400~2480MHz)
Antenna connector: IPEX MHF-1
Telemetry power: 12dbm
CRSF-PWM-V converter with barometer integrated
7x PWM outputs (6x with power rails, PWM8 is just a signal pad)
PWM frequency: 50, 100, 160, 330, 400Hz configurable
PWM resolution: 4x 1024 position + 3x 128 position(ExpressLRS 2.0 Wide switch mode)
1x UART(2) for GPS
36V Max. battery voltage sense (1K:10K voltage divider built-in)
Compatible with external Current sensor (0~3.3V)
RxBt,Curr,Capa,Bat%,GPS telemetry and VSpd(Vario)
Rated voltage: 3.5~9V @5V pad, 0~36V @Vbat, 0~3.3V @Curr
Power dissipation: 50mA(binding), 90mA(wifi mode)
No 5V regulator built-in, Servos must be powered via 5V pad on CRSF-PWM-V board by external 5V source.
Failsafe value configurable
Firmware upgradeable
Physical:
PCB Size: 27x16mm,
Weight: 5g w/ antenna and 2.54 pins
Packing:
1x ELRS-R24-V(includes CRSF-PWM-V and 2.4G Receiver)
1x IPEX MHF1 Antenna
2.54mm straight and 90° 3×6 Dupont pins
Firmwares
2.4GHz Receiver: ExpressLRS /DIY_2400_RX_ESP8285_SX1280, V2.0 or newer
CRSF-PWM-V: crsf_pwm_v2.0 or newer
Ada masalah dengan produk ini?
ULASAN PEMBELI
Belum ada ulasan untuk produk ini
Beli produk ini dan jadilah yang pertama memberikan ulasan