Cyclone V GT FPGA Development Kit

The Altera Cyclone V GT FPGA Development Kit can be used to prototype Cyclone V GT FPGA or Cyclone V GX FPGA applications. It offers a quick and simple way to develop low-cost and low-power FPGA system-level designs and achieve rapid results. This kit supports a myriad of functionalities such as: •FPGA prototyping •FPGA power measurement •Transceiver I/O performance up to 5.0 Gbps •PCI Express (PCIe) Gen2 x4 (at 5.0 Gbps per lane) •Endpoint or rootport support Specification FPGA Device Configuration and Debug Quad Serial Configuration device – EPCQ256 on FPGA On-Board USB Blaster (Normal Type-B USB connector) JTAG and AS mode configuration supported Configuration Communication Embedded USB-Blaster II (JTAG) Fast Passive Parallel (PFL) Intel EPCQ—EPCQ256SI16N (Quad Serial Configuration Device) Memory Device 384 MB x40 hard memory controller (HMC) DDR3 SDRAM with error correction code (ECC) 512 MB x64 soft memory controller (SMC) DDR3 SDRAM 1 Gb x16 sync flash Standard communication ports PCIe x4 edge connector Gigabit Ethernet (GbE) One SMA clock output Two universal high-speed mezzanine card (HSMC) connectors, each with four high-speed serial transciever channels One serial digital interface (SDI) channel —1 SMB for RX and 1 SMB for TX Channel shared with HSMA via resistor stuffing option Push buttons, DIP switches, and LEDs Clocking Programmable clock generator for FPGA reference clock input 125 MHz LVDS oscillator for FPGA reference clock input 148.5/148.35 MHz LVDS VCXO for FPGA reference clock input 50 MHz single-ended oscillator for FPGA and MAX V CPLD clock input 100 MHz single-ended oscillator for MAX V CPLD configuration clock input SMA input (LVPECL) Power Laptop DC Input 14 – 20 V adapter PCIe edge connector System monitoring circuit Power (Voltage, Current, Wattage) Mechanical PCIe card standard size (4.376 #34; x 6.600 #34;)