EMG Sensor Detector Arduino Raspberry Pi Grove

Kode Stock : 296-225

EMG detector is a bridge connects human body and electrical, the sensor gathers small muscle signal then process with 2th amplify and filter, the output signal can be recognized by Arduino. You can add this signal into your control system. Note: The sensor cannot be used for medical purposes.

In standby mode, the output voltage is 1.5V. When detect muscle active, the output signal rise up, the maximum voltage is 3.3V. You can use this sensor in 3.3V or 5V system.

Features :
Grove Compatible
3.5mm Connector
6 Disposable Surface Electrodes
Power supply voltage: 3.3V-5V
1000mm Cable Leads
No additional power supply

Move
When finish downloading demo code, it'll take about 5s to initialize, you should keep static when initializing.
You can see that when initializing, the Led Bar will go form level 10 to level 0. When Led Bar All off, you can move now.
When you are moving, you can find that the level of Led Bar will change.

Dimensions 140mm x100mm x30mm

Part List :
Grove - EMG Detector 1x
Grove Cable 1x
One-off electrode 6x
DC jacket to button connector cable 1000mm 1x

Datasheet : http://wiki.seeedstudio.com/Grove-EMG_Detector/