4.9/ 5.0
98% pembeli merasa puas
68 rating • 19 ulasan
5(65)95.59%
4(2)2.94%
3(1)1.47%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 52
Subtotal
Rp23.000
L293D L293 MOTOR DRIVER SHIELD
Rp23.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Motor drivers
Hi #RekanEasyWare ...
EasyWare Part#: EP000777
L293D is a monolithic integrated, high voltage, high current, 4-channel driver. Basically this means using this chip you can use DC motors and power supplies of up to 36 Volts, thats some pretty big motors and the chip can supply a maximum current of 600mA per channel. The L293D chip is also what's known as a type of H-Bridge. The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.
Spesifications :
- Motor voltage: 4.5V~25V
- Current: ≤1A
- 2 interface for 5V Servo connected to the high-resolution dedicated timer - no jitter.
- Can drive 4 DC motors or 2 stepper motors or 2 Servo.
- Up to 4 bi-directional DC motors with individual 8-bit speed selection.
- Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
- 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection.
- Pull down resistors keep motors disabled during power-up.
- Built In Reset Button.
- 2 external terminal power interface, for separate logic/motor supplies.
- Fully compatible for Mega, Diecimila & Duemilanove.
Package :
- 1x L293D MOTOR DRIVER SHIELD FOR ARDUINO
EasyWare Part#: EP000777
L293D is a monolithic integrated, high voltage, high current, 4-channel driver. Basically this means using this chip you can use DC motors and power supplies of up to 36 Volts, thats some pretty big motors and the chip can supply a maximum current of 600mA per channel. The L293D chip is also what's known as a type of H-Bridge. The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.
Spesifications :
- Motor voltage: 4.5V~25V
- Current: ≤1A
- 2 interface for 5V Servo connected to the high-resolution dedicated timer - no jitter.
- Can drive 4 DC motors or 2 stepper motors or 2 Servo.
- Up to 4 bi-directional DC motors with individual 8-bit speed selection.
- Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
- 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection.
- Pull down resistors keep motors disabled during power-up.
- Built In Reset Button.
- 2 external terminal power interface, for separate logic/motor supplies.
- Fully compatible for Mega, Diecimila & Duemilanove.
Package :
- 1x L293D MOTOR DRIVER SHIELD FOR ARDUINO
Ada masalah dengan produk ini?