wemos Nodemcu D1 mini is a mini wifi board based on ESP8266 ESP-12F

mohon dibaca seksama kak agar tidak ada kesalahpahaman port tidak terbaca part nodemcu kami versi terbaru dan baru 100% dijamin!!! untuk part ini driver menggunakan versi terbaru upgrade ft232rl / ftdi  pengganti ch340 yang kadang ga stabil tidak bisa  di windows 10 atau 11 ke atas, jadi ga usah ragu ya  berikut link driver nya  drive.googledotcom/file/d/145ZNyzEurseuIRWxEQheUnTHSO5wpnG-/view?usp=drive_link DOT GANTI TITIK YA hanya 2mb dan install aja , aman  atau link berikut cronyosdotcom/cara-install-driver-serial-programmer-ftdi-ft232/amp/ DOT GANTI TITIK YA pembelian banyak harga grosir nego di chat ya kak The D1 mini is a mini wifi board based on ESP-8266EX. ESP-12F # 11 digital input/output pins, all pins have interrupt/pwm/I2C/one-wire supported(except D0) # 1 analog input(3.3V max input) # a Micro USB connection # Compatible withArduino # Compatible with nodemcu Technical specs Microcontroller = ESP-8266EX Operating Voltage = 3.3V Digital I/O Pins = 11 Analog Input Pins = 1 Clock Speed = 80MHz/160MHz FLash = 4M bytes Length = 34.2mm Width = 25.6mm Weight = 10g Pin Function ESP-8266 Pin TX TXD TXD RX RXD RXD A0 Analog in(max 3.3V) A0 D0 IO GPIO16 D1 IO, SCL GPIO5 D2 IO, SDA GPIO4 D3 IO,Pull-up GPIO0 D4 IO,pull-up,LED GPIO2 D5 IO, SCK GPIO14 D6 IO, MISO GPIO12 D7 IO, MOSI GPIO13 D8 IO,pull-down, SS GPIO15 G Gound GND 5V 5V - 3V3 3.3V 3.3V RST Reset RST Programming The D1 mini has a micro USB for auto programming. Also you can programming it using OTA Warnings All IO is work at 3.3V.