How to connect SG90 : - The connection with Arduino is extremely easy - The servo has three leads - The brown one is the Ground so connect to it Arduino Ground - The red one is VCC which usually requires a voltage between four points eight to seven point two volts. So connect it to Arduino 5V - The last lead, the orange one is the control signal which needs to be a PWM signal with a periodic time of twenty milliseconds aka 50 Hertz And a duty cycle of one to two milliseconds so five to ten percent - While an on time of one millisecond represents the -90° position of the motor shafts, one point five milliseconds represent 0° position and two milliseconds the plus 90° position. That means you can rotate the shaft a total of 180° / 360°
Features: - Can run at 90°-180°/90°-360° at high - Low energy consumption and high efficiency - Adopted of high quality material, and accuracy process, for the durability - Small body, easy to install and remove - Suitable for planes and mini robots, etc
Specifications: - Operating speed: 0.1seconds/60degrees (4.8V) - Suspension torque: 1.6kg/cm (4.8V) - Temperature range: 0 C-55 C - Deadband Width: 10usec - Operating voltage: 4.8V ~ 6V - Suitable for all kinds of R / C toys - Connector cable length: 250mm - weight: 12.5g
Package includes: - 1set x Micro Servo Motor 9G SG90
Grosir: - 1 kg = 88 pcs - Harga grosir lebih murah - Reseller, dropshipper, dan beli banyak welcome :)
Ada masalah dengan produk ini?
ULASAN PEMBELI
5.0/ 5.0
100% pembeli merasa puas
2 rating • 0 ulasan
5
(2)100%
4
(0)0%
3
(0)0%
2
(0)0%
1
(0)0%
Belum ada ulasan untuk produk ini
Beli produk ini dan jadilah yang pertama memberikan ulasan