High Voltage 15KV Pulse Generator Arc Ignition Coil Module DIY Kit

Tinggalkan email anda lewat chat atau di keterangan untuk manual dalam PDF. Package Included: 15VKE 1 type stepup transformer x1 PCB Board X 1 120 ohm resistance X 1 UF4007 ultrafast recovery diode X 1 N20 transistor X 1 Heat sink X 1 M3 * 6 screws X 1 Boat switch X 1 3Pin X 1 Parameter: 15KV transformer outside dimensions of approximately: 271621mm Input voltage: DC 3.7V4.2V (limit 12v, easy to damage not recommended, this transformer is equally applicable to 12V input voltage, but requires a corresponding increase in the base of the feedback resistor to about 150 ~ 1.5K, its resistance should be large to replace a small adjustment, or burned transistor or transformer) Input Current: lt;2A Output voltage: approximately 15KV (please pay attention to safety when used) Output Current: 0.4A High voltage bipolar ignition distance: 0.5 cm Installation Notes: 1). With the PCB board parts better production, in which the transformer of thick and thin , this should pay attention to the other components by the board of silk symbols and parameters of welding on the . Transformer board has done three pads, in which the middle of the pad hole is relatively large, the hole at the same time welding a thick enameled wire and a thin enameled wire, thick enameled wire and fine enameled wire do not use the same side, such as with the left Thick s and the right side of the thin wire into or with the left side of the thin and the right side of the thick welding into, in short, do not use the same side of the thick s and thin s can be. 2). In order to prevent the output 2wire distance too far, resulting in noload, you can weld a 3P pin at the output. SKU : 3131/1148801834516398080/55