4.4/ 5.0
81% pembeli merasa puas
11 rating • 11 ulasan
5(6)54.55%
4(3)27.27%
3(2)18.18%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: 500
Subtotal
Rp79.000
Penggaris Busur Derajat / Alat Ukur Sudut PROTACTOR
Rp79.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Alat Kantor / ATK
Busur Derajat - Stainless Steel Protactor Sellery 54-700
- Length : 10cm.
- Angle : 0 - 180
- For Measuring Angles & Length.
Fitur :
- Pengukur sudut akurat sampai 1 derajat , cepat dan gampang pemakaiannya, lengkap dengan busur 180 derajat dan penggaris 10 cm.
- Berguna untuk mengukur sudut produk bubut, milling , bending, cutting , plate tekuk , dll.
Instruction:
- ZERO : loose screw and to turn handle ruler , then keep the handle ruler in the same level as the bottom of main plate . start line must be on 0 position. the way you can revise the protractor whether it is accurate or not.
- Measuring Angle : loose screw, the subject put on bottomof main plate handle ruler match to it , close the screw. after reading base line position on main plate.
- Measure width : 0-30cm metric system on the bottom of main plate. Base line put on 90 position , the subject match to handle ruler , bottom of main plate.
- Measure depth : handle ruler put on the cave or match the subject.
- Draw line : Loose screw , handle ruler adjust correct angle you would like , fix screw. Then you can draw lines on it.
- Length : 10cm.
- Angle : 0 - 180
- For Measuring Angles & Length.
Fitur :
- Pengukur sudut akurat sampai 1 derajat , cepat dan gampang pemakaiannya, lengkap dengan busur 180 derajat dan penggaris 10 cm.
- Berguna untuk mengukur sudut produk bubut, milling , bending, cutting , plate tekuk , dll.
Instruction:
- ZERO : loose screw and to turn handle ruler , then keep the handle ruler in the same level as the bottom of main plate . start line must be on 0 position. the way you can revise the protractor whether it is accurate or not.
- Measuring Angle : loose screw, the subject put on bottomof main plate handle ruler match to it , close the screw. after reading base line position on main plate.
- Measure width : 0-30cm metric system on the bottom of main plate. Base line put on 90 position , the subject match to handle ruler , bottom of main plate.
- Measure depth : handle ruler put on the cave or match the subject.
- Draw line : Loose screw , handle ruler adjust correct angle you would like , fix screw. Then you can draw lines on it.
Ada masalah dengan produk ini?