Modul ini adalah versi yang masih ideal, masih pakai Capacitor Tantalum berwarna kuning (vs warna hitam yang lebih inferior) dan komponen yang lebih premium. Akan lebih stabil saat pemakaian di Lab maupun di lapangan. (Lihat gambar no.3)
Ini bukan NodeMCU v3 yang LEBIH MURAH karena lebih besar dan memakai Chip USB yang lebih inferior, CH340.
Fakta tentang v3:
1. Bukan merupakan kelanjutan dari NodeMCU v2 dan diproduksi oleh produsen yang berbeda
2. Ukuran lebih besar (58 x 31mm) dibanding v2 (48 x 26mm)
3. Tidak breadboard-friendly, v3 akan memenuhi seluruh pin breadboard, sehingga tidak dapat digunakan untuk meng-koneksikan peripheral lain.
(Lihat gambar no.5)
Features:
+ MCU: Xtensa Single-core 32-bit L106
+ Typical Frequency: 80 MHz
+ Memory:
32 KiB instruction RAM
32 KiB instruction cache RAM
80 KiB user-data RAM
16 KiB ETS system-data RAM
+ External QSPI flash: 4 MB
+ Wireless 802.11 b / g / n standards
+ Support STA / AP / STA + AP three operating modes
+ Built-in TCP / IP protocol stack to support multiple TCP Client connection (5 max)
+ D0 ~ D8, SD1 ~ SD3: used as GPIO, PWM, IIC, etc. Port Drive 15mA
+ 10-bit ADC
+ Power input: 4.5 ~ 9V (10V Max), USB-powered, providing USB debugging interface
+ USB interface chip: CP2102
+ Current job: keep sending: ˜70mA (200mA Max), Standby: <200uA
+ Transfer rate: 110 - 460800bps
+ Support UART / GPIO data communication interface
+ Remote firmware upgrade (OTA)
+ Smart Link supports intelligent networking capabilities
+ Operating temperature: -40 ~ 125°C
+ Size: 48.5 x 25mm
+ Weight: about 7g
Video: https://youtu.be/IHocU-VqsF0
Link Arduino dan Atmel lainnya:
https://www.tokopedia.com/focuscamerashop/etalase/arduino-and-atmelLink ESP32 dan ESP8266 lainnya:
https://www.tokopedia.com/focuscamerashop/etalase/esp32-and-esp8266Arduino Compatible ESP32 ESP32s STM32 Wi Fi wireless MCU IoT Gateway MySensors Sensor Smarthome mesh network DIY