Whitenoise synergy F4 FC

The SynergyF4 was designed as an upgrade to your standard F4 flight controller with a focus on cleaner and easier building. A TBS Unify Pro V3 or a Unify Nano can be directly mounted to the surface of the board with no tape or zip ties required. In addition, the FrSky XM+ and TBS Crossfire Nano can be directly mounted to the board for a quick and easy build process. Solder bridge selectors on the bottom of the board allow for a wide range of components to be used with the FC. Note: This FC is still compatible with any receiver and video transmitter. Simply connect the rx/vtx with wires to the correct pads. Features Direct mounting for Unify Pro (5V) and Unify Nano (with adapter). Header holes for direct receiver installation. Built-in camera control via single wire (analog only) Built-in BetaflightOSD Buzzer: Dedicated pads for 5V (100mA max) buzzers. Onboard addressable LED. Built-in Tiny #39;s LEDs RealPit VTX power switch (selectable between ON-OFF-Remote) Receiver can be powered on via USB (VTX stays off) SmartAudio: Selectable between internal (FC controlled) and external (receiver). UART1: Receiver (FrSky, Spektrum, Crossfire, etc). UART3: SmartAudio (or any other desired output if SmartAudio is selected to pull signal from the #34;external #34; pad, designated RX SA on the top of the FC). UART6: ESC Telemetry (if applicable) or UART Cam control Specifications Processor: STM32F405 (F4 processor) Gyro: MPU6000 Loop: 8k/8k Input: 2-6S (Max 28V) Regulator: Filtered 5V 3A Receiver: 3.3V or 5V selectable. Inverted and non-inverted selectable receiver input. Connectors: 8 pin JST-SH main connector. 2x 3 pin JST-SH Addressable LED connectors (mirrored output) Telemetry: Current Sensor and ESC Telemetry Input Blackbox: 128Mb flash Motor: 4 PWM motor outputs with D-Shot and Mul