Matek F405 miniTE OSD Baro Ardupilot Inav HD Analog Flight Controller

STM32F405RGT6, ICM42605, SPL06, OSD, 6x UARTs, 1x I2C, 12x PWM outputs, BEC 5V amp; 10V. Convertible 20x20 or 30x30 it can run Ardupilot, Inav, or Betaflight! This F405 flight controller has a full 1MB of flash, which means that it can run Ardupilot and even support features of Inav that some F722 FC cannot due to smaller flash. This 20×20 board also include a 30×30 adapter giving you more mounting options. It also includes 8 motor outputs and support for DJI HD FPV system. The new features of F405-miniTE compared with F722-miniSE (EOL) F405 has 1MB flash which can run with ArduPilot. even with INAV firmware, some features will be removed on F722 due to limited flash. The advantage of F722 is all UARTs have built-in inversion which is not needed when CRSF protocol is widely used on new receivers. Redesigned target MATEKF405TE support 8x bi-directional DSHOT. Support DJI air unit PnP, and a 10V BEC for DJI OSD or analog VTX Compared with F722-miniSE 8motors or 6motor+2servos, F405-miniTE support 8motors+3servos in INAV/BF multirotor mixer InvenSense GEN3 IMU ICM42605 FC Specifications MCU: STM32F405RGT6 IMU: ICM42605 OSD: AT7456E Baro: Goertek SPL06-001 (I2C) Blackbox: 16M-byte Flash memory 6x UARTs, 1x Softserial_Tx option 12x PWM outputs (8x Dshot) 1x I2C 4x ADC (VBAT, Current, RSSI, Airspeed) 2x PINIO 1x SH1.0_8pin connector (Vbat/G/Curr/R3/S1/S2/S3/S4) 1x SH1.0_6pin connector for DJI FPV Air Unit 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red) Dual BEC, 5V 1.7A amp; 10V 1.4A 10V output ON/OFF switchable Convertible 20mm to 30.5mm mounting Firmware ArduPilot: MatekF405-TE INAV: MATEKF405TE (not available in INAV configurator for now) BetaFlight: MATEKF405TE Including 1x FC F405-miniTE 1x 20mm to 30.5mm conversion plate(blue PCB) 6x Silicon grommets M4 to M3 6x Brass grommets M3 to M2 1x SH1.0_8pin cable 5cm (including 2x 8pin connectors) for 4in1 ESC 1x SH1.0_6pin to GH1.25_8pin cable 8cm for DJI Air Unit