Atur jumlah dan catatan
Stok Total: Sisa 4
Subtotal
Rp2.295.000
NewBeeDrone X Fettec Infinity AIO G4 45A 3-6S Flight Controller FC ESC
Rp2.295.000
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: Flight Controller PDB BEC Other Boards
Specification:
Microcontroller Unit (MCU) :
MCU: STM32G474 Running FETTec Alpha Firmware 0.7-62
Gyro: MPU6000
4x STM32G071 @64MHz FETtec ESC MCU Running FETTec ESC Firmware 1.0-241
Connectivity:
6-Pin DJI FPV Air Unit Connector
Micro USB Connector
UART1: DJI Connector
UART2: Used for Receiver
UART3: Free (also connect to Fettec Analog Onboard OSD)
UART4: Free
UART5: Used for ESCs / TLM / Onewire
OneWire BUS with up to 8kHz looptime (one cable for all Motor signals and Telemetry)
Power Specifications:
Continuous Current 45A and 55A Burst ESC
Dshot 300-2400
3-6S Battery Input
12V 2A Design for DJI FPV Air Unit
5V 3A Power supply for external LED or GPS module
Physical Characteristics:
Dimensions: 41x37x7.6mm with 30.5x30.5mm Mounting Holes
Weight: 19.4gr with grommets, 18.8gr without grommets
Additional Features:
FETTEC OSD support for Analog build
Buzzer Ready
4x LED
Note For Analog Build:
Analog build will need to setup Serial 3 to talk to the internal Analog OSD Chips.
Please follow the setting below to enable the Analog OSD chips.
Settings>FC Setup>Serial
MSP Port1 - Serial3
Microcontroller Unit (MCU) :
MCU: STM32G474 Running FETTec Alpha Firmware 0.7-62
Gyro: MPU6000
4x STM32G071 @64MHz FETtec ESC MCU Running FETTec ESC Firmware 1.0-241
Connectivity:
6-Pin DJI FPV Air Unit Connector
Micro USB Connector
UART1: DJI Connector
UART2: Used for Receiver
UART3: Free (also connect to Fettec Analog Onboard OSD)
UART4: Free
UART5: Used for ESCs / TLM / Onewire
OneWire BUS with up to 8kHz looptime (one cable for all Motor signals and Telemetry)
Power Specifications:
Continuous Current 45A and 55A Burst ESC
Dshot 300-2400
3-6S Battery Input
12V 2A Design for DJI FPV Air Unit
5V 3A Power supply for external LED or GPS module
Physical Characteristics:
Dimensions: 41x37x7.6mm with 30.5x30.5mm Mounting Holes
Weight: 19.4gr with grommets, 18.8gr without grommets
Additional Features:
FETTEC OSD support for Analog build
Buzzer Ready
4x LED
Note For Analog Build:
Analog build will need to setup Serial 3 to talk to the internal Analog OSD Chips.
Please follow the setting below to enable the Analog OSD chips.
Settings>FC Setup>Serial
MSP Port1 - Serial3
Ada masalah dengan produk ini?
ULASAN PEMBELI
Belum ada ulasan untuk produk ini
Beli produk ini dan jadilah yang pertama memberikan ulasan