VKB Gladiator NXT Stand Alone Module GNX THQ (Tabletop Module)

A USB connection is not included by default because GNX modules are specifically designed to be connected to Gladiator NXT/EVO joysticks, allowing them to function together as a single integrated device through their internal BUS interface.
If you want to use a GNX module on its own, directly connected to your PC, you'll need to separately purchase and install a GNX USB Controller (HID-Main) to replace the module's default GNX BUS Interface.


Included

1x THQ Module
1x Plastic Coupler
1x Type-C Connector Guard
1x Set of Rubber Pads
1x Set of Plastic Spacers
1x Set of Interchangeable Heads
1x Set of Metal Levers (Long)
1x Set of Plastic Levers (Short)
1x Internal "Module-to-Module" Cable
1x Internal "Module-to-Joystick" Cable
1x Phillips Screwdriver
1x HEX Screwdriver
1x Set of Stickers with Protective Film
Tabletop module
A GNX tabletop module can be attached side-by-side to the following devices:

Gladiator NXT/EVO joystick base (from either side)
Gladiator NXT EVO Omni Throttle (from the opposite side of the OTA elbow)
SEM modules (up to a total of 4 SEM modules)
THQ modules (up to a total of 4 THQ modules)
Recommendation

If you want to use a GNX module on its own, directly connected to your PC, you'll need to separately purchase and install a GNX USB Controller (HID-Main) to replace the module's default GNX BUS Interface.
Features
Utilizes the newly developed VKB Njoy 32NG firmware, allowing recognition of up to 20 analog axes in Windows, divided into 3 devices.

3x Analog Axes (with clutch dampers and adjustable length/height of axis levers)
8x Push Buttons
5x Interchangeable Axis Lever Heads (different colors/shapes)
Connect up to 4x GNX THQ modules, providing a total of 12 analog axes
Video Guides:

Attaching a THQ to a Gladiator NXT/EVO
List of all THQ related video guides
Profile Templates

Find them in our Downloads Section
Compatible with

Gladiator NXT/EVO
Gladiator NXT/EVO Omni Throttle
UCM Stronghold
GNX USB Controller (HID-Main)