Yamaha MG124CX

Description 12-input, 4-bus design 4 channels of single-knob compression Built-in DSP for high quality effects 3-band EQ on inputs Illuminated Channel On/Off switches Frequency response: Stereo Out, Group OUT, EFFECT/AUX (AUX1, 2*), SEND, Monitor OUT, Rec Out: -3.0 — 1.0dB Total Harmonic Distortion (THD + N) Stereo Out, +14dBu @ 20Hz-20kHz, Input Gain Control at minimum: 0.1% Hum Noise: CH Input 1-4 MIC, EIN (Equivalent Input Noise): Rs = 150Ω, Gain: maximum: -128dBu Stereo Out Group OUT, Stereo Out, Group Master fader at nominal level and all channels' ST and 1-2 switches off: -88dBu EFFECT/AUX (AUX1, 2*) SEND, Master EFFECT/AUX (AUX1, 2) control at nominal level and all CH EFFECT/AUX (AUX1, 2) controls at minimum.: -81dBu Stereo Out Group OUT, Stereo, Group Master fader and one CH fader at nominal level: -64dBu Stereo Out Residual Output Noise -98dB Crosstalk (1kHz): Adjacent Input CH 1-4: -70dB; Input to Output Stereo L/R, CH 1-4, PAN: panned hard left or right: -70dB Phantom Voltage MIC: + 48V Input HPF: CH 1-7/8, 80Hz, 12dB/oct Input equalization CH 1-7/8 HIGH: 10kHz (shelving), MID: 2.5kHz (peaking), LOW: 100Hz (shelving); CH 9/10-11/12 HIGH: 10kHz (shelving), LOW: 100Hz (shelving) PEAK Indicator: Red LED turns on when post EQ signal (either post MIC HA or post EQ signal for CH 5/6, 7/8) reaches -3dB below clipping (+17dBu). Internal Digital Effect*: 16 PROGRAM, PARAMETER control, Foot Switch (Digital Effect On/Off) LED Level Meter Pre Monitor Level: 2 x 12 points LED meter (PEAK, +10, +6, +3, 0, -3, -6, -10, -15, -20, -25, -30dB), PEAK lights if the signal level reaches 3dB below the clipping level. Power Supply Adaptor PA-20: AC 35 VCT, 0.94 A, Cable Length = 3.6 m Power Consumption: 30 W Dimensions (WxHxD): 19.5\ x 18.5\ x 7.3\ (346.2mm x 86.1mm x 436.6mm) Weight: 16.5lb. (3.2kg)