Mobile Phone Nfc Induction Relay Control Module Car Door Modification

Selamat Datang di Toko Kami. - Kami Menjual Produk-produk Import - Produk Dikirim dari Luar Negeri. - Estimasi Kiriman 5-15 Hari. Mohon Menunggu Model Number : SY-230D Item Type : Exit Button Smartphone NFC fingerprint relay control panel IC 13.56mhz two-channel relay module car electric bicycle modification accessories Product parameters: Input voltage: DC10V-DC120V Read card type: 13.56mhz Unlocking method: IC card, fingerprint, mobile phone NFC Card storage capacity: 100pcs Fingerprint storage capacity: 300pcs Control mode: 10 control modes (Relay delay and waiting time can be adjusted) Note: Before using NFC, you need to turn on the NFC switch in the phone Settings. Android phones can be used only after you have created a blank card in the Wallet APP. For iPhone, you need to add any bus card or bank card into the #34;Wallet #34; APP of the phone. The bus card can be sensed only after it has been recharged. Blinking blue once: indicates relay mode 1 1Fingerprint or card unlocked successfully, 3V interface output, wait for 1S, relay 1 connected 0.5S disconnect. The fingerprint or card is unlocked successfully again. 2The relay 2 is disconnected after 0.5 seconds of connection, and the 3V interface is powered off. Blinking blue twice: indicates relay mode 2 1If the fingerprint or card is unlocked successfully, relay 1 is connected; If the fingerprint or card fails to be unlocked again, relay 1 will be disconnected. 2If the fingerprint or card is successfully unlocked again, relay 2 will also be connected. After releasing the finger or removing the card, relay 2 will power off immediately. 3Verify the card or fingerprint again, and disconnect relay 1 regardless of success or failure. Blinking blue three times: indicates relay mode 3 1If the administrator fingerprint or management card is unlocked successfully, relay 1 is connected. After it is unlocked successfully again, relay 1 is disconnected. 2If the fingerprint or user card of the common