Atur jumlah dan catatan
Stok Total: 188
Subtotal
Rp254.520
3.3-5V RFID Card Reader Module 125khz Card Reader Built-in Antenna RF Module UART Serial Output Super RDM6300
Rp254.520
- Kondisi: Baru
- Waktu Preorder: 30 Hari
- Min. Pemesanan: 1 Buah
- Etalase: Semua Etalase
1005004046611647
Selamat Datang Di Toko Kami
Semua Barang PreOrder 15-30 Hari
Selamat Belanja
Brand Name : Ziqqucu
Model Number : Card Reader Module
Origin : Mainland China
Type : Drive IC
Supply Voltage : 3.3-5V
is_customized : Yes
Condition : New
Package : TQFP
Support dropshipping and wholesaling.
100% Original and with free after-sale warranty.
Description:
1. This product is a 125KHz RFID swipe decoding module, and integrates the antenna in the PCB.
2. The interface adopts 5PIN interface, which are VCC, J1, Tx, J2, GND. At the same time, Schottky diode is added to the power supply for anti-reverse connection protection.
3. This module is suitable for most low frequency ID cards.
4. The module has 3 output modes: UART output, IO direct output, and triode open-drain output.
5. Wide application
Specification:
Product Name: Integrated Antenna RF Card Swipe Module
Supply voltage: 3.3-5V (5V recommended)
Operating current: less than 50mA, the typical value is 35mA.
Serial port parameters: baud rate 9600 bit/s, data bit 8 bit, no parity check, 1 bit stop bit
Interface function:
The module adopts three kinds of interface output
1. Pin Tx uses UART to output data, the output data format is 10 ASCII codes + 1 space, and the card number is 10 data (see Figure 1). The baud rate setting is sampled in the manner of Figure 1 to receive data.
2. If the product does not need to use the UART to read the specific card number, you can directly read whether the card swipe is successful through the IO port of J2. When the card is swiped successfully, it will be accompanied by UART data output. During the data output period, the J2 port remains high. After the data output is completed or in the idle state, it always outputs a low level.
The J1 port and the J2 port have an opposite level, but the port is an open-drain output, and the corresponding level can be output through a pull-up resistor. It can also be connected to 12V load and 24V load. This port is designed to be upgraded for subsequent products, driving relays, etc. The sink current of the port cannot exceed 100mA. (If the customer needs to directly drive the relay, the corresponding program needs to be replaced)
Package Contents:
1*Integrated antenna RF card swiping module*1+pin header
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
About Us
We provide the good product with the best price,we support Wholesale/Drop Shipping Order
1. For Drop Shipping order, please remark"dropshipping order", we will prioritize it.
2. For Wholesale/Drop Shipping orders, if you have any ideas about the price or package,please contact us in advance,we will give you the best service to satisfy your demands.
About Payment
If you meet any problem when making the payment, please contact Customer Service Center to ask for help:
#
About Shipments
1.We will send out the orders ASAPwithin 2-5 days(except weekends and national holidays) once your payment is completed normally.
2.Please write your complete delivery address with correct phone number and zip code, especially Russia and Belarus buyers,please confirm your full name.
3.Please notice that we will not responsible for customs duties.Please do the customs clearance by yourself.
4.We provide both post shippingand express shippings.For most countries, post shipping takes about 25-35 business days, and longer for some countries like Brazil, Peru.
Express shipping inlcudeDHL, EMS, Premium Shipping and Special Lines like Aramex. It takes about 7 days.(It will delay if your country meet some problem,Worker strike,weather problem and so on.)
About After-sale Service
We are reliable seller and we have ourprofessionalafter-sale service for all of our customs. If there is any question about the order,please contact us in advance ,we will always here until you get a happy answer.
About Feedback
1. Please check the package and item when you get carefully to make sure there is no problem.
2. If you have any problem or are not entirely satisfied with your package,please dont be hesitate to contact us first before leaving negative feedback. We will resolve the problem to satisfy you.
3. If there is no problem, please leave us 5 star positive feedback.
Your affirmation is our greatest motivation ! ! !
Selamat Datang Di Toko Kami
Semua Barang PreOrder 15-30 Hari
Selamat Belanja
Brand Name : Ziqqucu
Model Number : Card Reader Module
Origin : Mainland China
Type : Drive IC
Supply Voltage : 3.3-5V
is_customized : Yes
Condition : New
Package : TQFP
Support dropshipping and wholesaling.
100% Original and with free after-sale warranty.
Description:
1. This product is a 125KHz RFID swipe decoding module, and integrates the antenna in the PCB.
2. The interface adopts 5PIN interface, which are VCC, J1, Tx, J2, GND. At the same time, Schottky diode is added to the power supply for anti-reverse connection protection.
3. This module is suitable for most low frequency ID cards.
4. The module has 3 output modes: UART output, IO direct output, and triode open-drain output.
5. Wide application
Specification:
Product Name: Integrated Antenna RF Card Swipe Module
Supply voltage: 3.3-5V (5V recommended)
Operating current: less than 50mA, the typical value is 35mA.
Serial port parameters: baud rate 9600 bit/s, data bit 8 bit, no parity check, 1 bit stop bit
Interface function:
The module adopts three kinds of interface output
1. Pin Tx uses UART to output data, the output data format is 10 ASCII codes + 1 space, and the card number is 10 data (see Figure 1). The baud rate setting is sampled in the manner of Figure 1 to receive data.
2. If the product does not need to use the UART to read the specific card number, you can directly read whether the card swipe is successful through the IO port of J2. When the card is swiped successfully, it will be accompanied by UART data output. During the data output period, the J2 port remains high. After the data output is completed or in the idle state, it always outputs a low level.
The J1 port and the J2 port have an opposite level, but the port is an open-drain output, and the corresponding level can be output through a pull-up resistor. It can also be connected to 12V load and 24V load. This port is designed to be upgraded for subsequent products, driving relays, etc. The sink current of the port cannot exceed 100mA. (If the customer needs to directly drive the relay, the corresponding program needs to be replaced)
Package Contents:
1*Integrated antenna RF card swiping module*1+pin header
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
About Us
We provide the good product with the best price,we support Wholesale/Drop Shipping Order
1. For Drop Shipping order, please remark"dropshipping order", we will prioritize it.
2. For Wholesale/Drop Shipping orders, if you have any ideas about the price or package,please contact us in advance,we will give you the best service to satisfy your demands.
About Payment
If you meet any problem when making the payment, please contact Customer Service Center to ask for help:
#
About Shipments
1.We will send out the orders ASAPwithin 2-5 days(except weekends and national holidays) once your payment is completed normally.
2.Please write your complete delivery address with correct phone number and zip code, especially Russia and Belarus buyers,please confirm your full name.
3.Please notice that we will not responsible for customs duties.Please do the customs clearance by yourself.
4.We provide both post shippingand express shippings.For most countries, post shipping takes about 25-35 business days, and longer for some countries like Brazil, Peru.
Express shipping inlcudeDHL, EMS, Premium Shipping and Special Lines like Aramex. It takes about 7 days.(It will delay if your country meet some problem,Worker strike,weather problem and so on.)
About After-sale Service
We are reliable seller and we have ourprofessionalafter-sale service for all of our customs. If there is any question about the order,please contact us in advance ,we will always here until you get a happy answer.
About Feedback
1. Please check the package and item when you get carefully to make sure there is no problem.
2. If you have any problem or are not entirely satisfied with your package,please dont be hesitate to contact us first before leaving negative feedback. We will resolve the problem to satisfy you.
3. If there is no problem, please leave us 5 star positive feedback.
Your affirmation is our greatest motivation ! ! !
Ada masalah dengan produk ini?
ULASAN PEMBELI
Belum ada ulasan untuk produk ini
Beli produk ini dan jadilah yang pertama memberikan ulasan