30cm Acrylic Bending Machine with Angle Adjuster Watercooling Advertising Bender for Plastic PVC Board

Main functions and purposes
Different sizes to meet your needs
SJ-600  Effective width:60cm ,800W ,220V
SJ-1800 Effective width:180cm,1800W 220V
SJ-2400 Effective width:250cm,2300W ,220V
1.      Get a tank or bucket with a capacity of 30L and above, fill it with water for the cooling purpose. Connect the heater (bending machine) and the pump with silica pipe, and then place the pump into the tank or bucket. Switch on power supply for the pump; wait for the water to run smoothly within the pump and pipes.
(Note: After long hours of work, the water may get hot, and it needs to be replaced. Also , don’t replace the hot water immediately with very cold water; when the water temperature gets around 50 degree, just switch off the power/thermostat, wait for a while and then replace the )
2.      Fit the thermostat with the heater (bending machine), and switch it on. Turn the thermostat clockwise, the temperature will rise; if anti-clockwise, the temperature drops. Do not turn the thermostat very quickly, or it may not be so accurate to control the temperature. (Note: Slowly turn the thermostat until you see the heating part becoming fire-red. Extremely high temperature may burn your material to be processed, and the service life of the machine may also be shortened.)
3.      After reaching the needed temperature, place the plastic material on the heating area; make it hot and soft enough for you to bend it with your hands. The time required for heating depends on the materials to be processed, and you can decide on this according to your past experiences.
Tips
If you’re not familiar with hot-bending, then find a small piece of material of the same quality and thickness as the big sheet waiting to be processed. You place this small piece on the heating area and turn the thermostat to find the right heating duration and temperature for the material (with the proper temperature, the material will become soft enough quite quickly and blisters won’t be caused;