NodeMCU V3 ESP8266 ESP8266-E12 CH340 IOT wireless Arduino

NODEMCU WIFI V1 4MB 32MBITS CH340 FLASH ESP8266 ESP12 BOARD

Deskripsi :
Board LOLIN ini ukurannya lebih besar dari yang versi DOIT!

Board ini merupakan board yang dapai kita pakai untuk berbagai projek IOT
Untuk pemrogramannya sendiri tentu bisa kita perogram melalui aplikasi IDE arduino.

Spesifikasi :
=================================
- Uses CH340G
- NodeMCU has built-in USB-TTL serial with super reliable industrial strength CH340G for superior stability on all supported platforms.
- Communication interface voltage: 3.3V.
- Antenna type: Built-in PCB antenna is available.
- Wireless 802.11 b/g/n standard
- WiFi at 2.4GHz, support WPA / WPA2 security mode
- Support STA/AP/STA + AP three operating modes
- Built-in TCP/IP protocol stack to support multiple TCP Client connections (5 MAX)
- D0 ~ D8, SD1 ~ SD3: used as GPIO, PWM, IIC, etc., port driver capability 15mA
- AD0: 1 channel ADC
- Power input: 4.5V ~ 9V (10VMAX), USB-powered
- Current: continuous transmission: 70mA (200mA MAX), Standby: 200uA
- Transfer rate: 110-460800bps
- Support UART / GPIO data communication interface
- Remote firmware upgrade (OTA)
- Support Smart Link Smart Networking
- Working temperature: -40 ~ + 125
- Drive Type: Dual high-power H-bridge driver
-- Flash size: 4MByte

Dalam penjualan barang ini hanya mikrokontrollernya saja, belum termasuk kabel micro usb ya gan, usb nya bisa beli sendiri yaa, atau bisa menggunakan kabel charger HP android yang micro-USB ya

Stok ready selama masih dipajang ya ges ya :)