WEP 982D-I Desoldering Tweezers Station Rework Soldering Station With Automatic Calibration

Informasi Produk WEP 982D-I Desoldering Tweezers Station Rework Soldering Station With Automatic Calibration

Applications

Suitable for desoldering and soldering various surface-mount and through-hole components, especially ideal for manufacturing. work in factories. This tool can solder two solder joints at once, allowing for high efficiency soldering.

Maintenance & Precautions

1. If a layer of oxidization forms on the surface of the soldering iron tip, a misconception can be created that the tip cannot heat up properly to melt the solder and do the tinning. However, the actual temperatures of both the heating element and the tip are high. such an instance, please do not increase the temperature value further but use a metal wool ball to remove the oxidization
following the steps below:
A. Set the temperature to 300°C(572°F).
B.Once the temperature stabilizes, gently rub the soldering iron tip inside the metal wool ball.
C. When the oxidization is partially removed, continue applying solder onto the soldering iron tip while rubbing it until the tip is completely coated with solder. If the tip is too severely oxidized beyond cleaning, replace it with a new one.

2.DO NOT use metal files to remove the oxidization on the soldering iron tip. If the soldering iron tip deforms or rusts, replace the soldering iron tip with a new tip.

3.DO NOT apply excessive force on the soldering iron tip when soldering. This will not improve the heat transfer and damage the soldering iron tip instead.

4.Clean the soldering iron tip after use and tin the tip with a new layer of solder to prevent oxidization.

5.Clean the Residue Tray (Rear)

Please clean the residue tray(Rear) when the station is disconnected, fully cooled and the residue tray (Front) is empty. 5-1 Remove the solder dispenser, cleaning sponge, soldering iron and heating element inside the groove (For Heating Element

Change) 5-2 Place the station sideways and unscrew the locking screw to the residue tray (Rear). Remove the tray to clean the residue

inside the tray

5-3 Install the residue tray (Rear) and tighten the locking screw.

6.Change the sensor module: Unscrew the locking screw to remove the original sensor module. Please note to connect positive and negative ends correctly before installing the new sensor module and tightening the locking screw.

Kelengkapan Produk
1xWEP 982D-I Desoldering Tweezers Station Rework Soldering Station With Automatic Calibration

Specification
Rated voltage range 110-240v
Rated power 90w
Display LED
Operating ambient temp. 0C~40C/32F~104F
Operating ambient temp. 90C~450C/194F~842F