5.0/ 5.0
100% pembeli merasa puas
3 rating • 2 ulasan
5(3)100%
4(0)0%
3(0)0%
2(0)0%
1(0)0%
Atur jumlah dan catatan
Stok Total: Sisa 6
Subtotal
Rp14.800
Lithium Battery Charger Board 1A + Discharge cut off protection
Rp14.800
- Kondisi: Baru
- Min. Pemesanan: 1 Buah
- Etalase: tool
charger untuk segala lithium, LiIon, LiPo, arus default 1 Ampere, dapat diatur arusnya pengisian dengan mengganti nilai resistor, direkomendasikan untuk mengatur arus sebesar 37% dari kapasitas total baterai.
cara mengganti resistor dapat melihat datasheet IC controller.
datasheet : https://dlnmh9ip6v2uccloudfrontnet/datasheets...
modul ini dilengkapi perlindungan pemakaian berlebih, untuk mencegah baterai terkuras terlalu besar ( V batt kurang dari 2.7v maka akan cut off ). baterai akan kembali normal ketika dilakukan pengisian sampai penuh.
Charge module- Linear charging.
Current- 1A adjustable.
Charge precision- 1.5%.
Input voltage- 4.5V-5.5V.
Full charge voltage- 4.2V.
Led indicator- red is charging Green is full charged.
Input interface- micro USB.
Work temperature- -10 to +85.
Inversed polarity- NO.
Size- small to 25X19X10mm.
NOTE:
1. Ampere meter can only be connected to 5v input end of the module.
2. It is better that the charging current is 37% of the battery capacity. If you charge to the battery of 1000mAH, current of 400 is enough.
3. The connection wire should not be too thick.
4. Make sure the connect point is good.
5. If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-substract the charging current to avoid burn damage to chip.
6. NO Reveral polarity.
cara mengganti resistor dapat melihat datasheet IC controller.
datasheet : https://dlnmh9ip6v2uccloudfrontnet/datasheets...
modul ini dilengkapi perlindungan pemakaian berlebih, untuk mencegah baterai terkuras terlalu besar ( V batt kurang dari 2.7v maka akan cut off ). baterai akan kembali normal ketika dilakukan pengisian sampai penuh.
Charge module- Linear charging.
Current- 1A adjustable.
Charge precision- 1.5%.
Input voltage- 4.5V-5.5V.
Full charge voltage- 4.2V.
Led indicator- red is charging Green is full charged.
Input interface- micro USB.
Work temperature- -10 to +85.
Inversed polarity- NO.
Size- small to 25X19X10mm.
NOTE:
1. Ampere meter can only be connected to 5v input end of the module.
2. It is better that the charging current is 37% of the battery capacity. If you charge to the battery of 1000mAH, current of 400 is enough.
3. The connection wire should not be too thick.
4. Make sure the connect point is good.
5. If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-substract the charging current to avoid burn damage to chip.
6. NO Reveral polarity.
Ada masalah dengan produk ini?