Diskon Fysetc 3D Printing Buildplate 300X300Mm11.8X11.8 Inch Steel

Fysetc 3D Printing Buildplate 300X300Mm/11.8X11.8 Inch Steel Spring Sheet Bed Printing Hotbed Parts Steel Plate With Pei + Sticker Surface For Taz 6 Ender 6 This Pei Flexible Heated Bed Is Combined With 2 Parts: A Flexible Steel Platform Sticking With A Pei Sheet On One Side + A Sticker Bottom Sheet With Adhesive On The Back. The Pei Comes Pre Applied. If Want To Leave A Frosted Bottom On Your Print, Please Search Our Double-Sided Textured Pei Powder(Asin: B07V9Dy7Sm / B088Tbzsv6 ) At The Shop. Size:300 X 300Mm/11.8X11.8 Inch, Please Re-Measure Your Build Plate, Don #39;T Refer To Build Volume.Fits: Taz Workhorse, Taz Pro, Taz 6, Taz 5, Taz 4, Taz 3, May Fit: A8 Plus, Et5 And Et5 Pro, Ender 6?290X290Mm? Our Sticker And Films Have All Been Formulated To Resist Over 130? / 226F So You Can Heat Your Bed To High Temps For Specialty Filaments And Not Worry About Loss Of Performance The Pei Has Been Pasted, If Pei Is Damaged During Use, You Can Tear It Off From The Steel Plate And Purchase The Pei Separately To Replace It. After Printing Or Before Printing, Use Steel Wool Pads With Detergent To Clean The Pei Sheet, Will Keep The Pei Like New, Give The Pei More Life. But Be Make Sure The Hotbed Is Cold. Before Printing, Please Remove The Protect Film Which Stick On The Pei Surface, So If You Received Package But Found The Air Bubbles Or Scratches, Please Don #39;T Worry, They Are The Surface Layer, Pei Will Not Be Affected. Barang Pre-Order Tanyakan stock dan varian (jika ada opsi) sebelum order