Arduino Giga R1 WiFi STM32H747XI 32-bit Microcontroller

PRODUK PRE-ORDER - Harga dapat berubah sewaktu-waktu, mohon konfirmasi terlebih dahulu sebelum order. - Tidak bisa cancel setelah order dikonfirmasi. - Estimasi waktu pre-order sekitar 15-45 hari, tergantung dari lamanya pengiriman. - Produk Arduino dijamin original karena kami ambil barang langsung dari official distributor luar maupun dalam negeri. The GIGA R1 WiFi is a powerful, feature-packed board with a large amount of GPIOs and dedicated connectors. Based on the STM32H747XI micro based on the Mbed OS, the GIGA R1 WiFi features 76 GPIOs, a dual core processor, advanced ADC/DAC features as well as camera amp; display connectors. It also has a rich USB interface with support for HID via USB-C and USBHost (keyboard, mass storage) via a dedicated USB-A connector. Microcontroller (STM32H747XI): This dual core 32-bits microcontroller allows you have two brain talking to each other (a Cortex-M7 at 480 MHz and a Cortex-M4 at 240 MHz) you can even run micropython in one and Arduino in the other. Arduino GIGA R1 WiFi SKU ABX00063 Microcontroller: STM32H747XI dual Cortex-M7+M4 32bit low power Arm MCU USB-C: Programming Port / HID USB-A: Host (enable with PA_15) Digital I/O Pins: 76 Analog input pins: 12 DAC: 2 (DAC0/DAC1) PWM pins: 12 Misc VRTC amp; OFF pin UART: Yes, 4x I2C: Yes, 3x SPI: Yes, 2x CAN: Yes (requires an external transceiver). Connectors Camera: I2C + D54-D67 Display: D1N, D0N, D1P, D0P, CKN, CKP + D68-D75 Audio Jack: DAC0, DAC1, A7 Power Circuit operating voltage: 3.3V Input voltage (VIN): 6-24V DC Current per I/O Pin: 8 mA Clock speed Main core: 480 MHz Second core: 240 MHz Memory STM32H747XI: 2MB Flash, 1MB RAM Dimensions Width: 53.3 mm Length: 101.5 mm