Terasic Altera Cyclone V GX FPGA Starter Kit

PRODUK PRE-ORDER
- Harga dapat berubah sewaktu-waktu, mohon konfirmasi terlebih dahulu sebelum order.
- Tidak bisa cancel setelah order dikonfirmasi.
- Estimasi waktu pre-order sekitar 15-30 hari, tergantung dari lamanya pengiriman.
- Kami bisa bantu klaim garansi ke distributor, namun Invok Lab tidak dapat menanggung biaya kirimnya. Diterima atau ditolaknya klaim garansi adalah 100% keputusan dari distributor.
- Produk TERASIC dijamin original karena kami ambil barang langsung dari official distributor luar maupun dalam negeri.
- Kami juga melayani konsultasi dan pengadaan komponen, sensor, dan lain-lain untuk proyek elektronik anda.

The Cyclone V Starter Kit presents a robust hardware design platform built around the Altera Cyclone V GX FPGA, which is optimized for the lowest cost and power requirement for transceiver applications with industry-leading programmable logic for ultimate design flexibility.
With Cyclone V FPGAs, you can get the power, cost, and performance levels you need for high-volume applications including protocol bridging, motor control drives, broadcast video converter and capture cards, and handheld devices.
The Cyclone V Starter Kit development board includes hardware such as Arduino Header, on-board USB Blaster, audio and video capabilities and much more. In addition, an on-board HSMC connector with high-speed transceivers allows for an even greater array of hardware setups.
By leveraging all of these capabilities, the Cyclone V Starter Kit is the perfect solution for showcasing, evaluating, and prototyping the true potential of the Altera Cyclone V GX FPGA.
FPGA Device

Cyclone V GX 5CGXFC5C6F27C7N Device
77K Programmable Logic Elements
4884 Kbits embedded memory
Six Fractional PLLs
Two Hard Memory Controllers
Six 3.125G Transceivers
Configuration and Debug

Quad Serial Configuration device – EPCQ256 on FPGA
On-Board USB Blaster (Normal Type-B USB connector)
JTAG and AS mode configuration supported
Memory Device

4Gb LPDDR2 x32 bits data bus
4Mb SRAM x16 bits data bus
Communication

UART to USB
Expansion I/O

HSMC x1 (voltage levels: 2.5V), including 4-lanes 3.125G transceiver
2x20 GPIO Header (voltage levels: 3.3V)
Arduino header, including analog pins
SMA x4 (DNI), one-lane 3.125G transceiver
Display

HDMI TX, compatible with DVI v1.0 and HDCP v1.4
Audio

24-bit CODEC
Line-in, line-out, and microphone-in jacks
Switches, Buttons, LED, and 7-Segments

18 LEDs
10 Slide Switches
4 Debounced Push Buttons
1 CPU reset Push Button
Four 7-Segments
Micro SD Card Socket

Provides SPI and 4-bit SD mode for SD Card access
ADC

12-Bit Resolution, 500Ksps Sampling Rate
SPI Interface
8-Channel Analog Input
Input Range: 0V ~ 4.096V
Power

12V DC input