Notifier FAPT-851 MultiSensor Detector tanpa base

The Notifier FAPT-851(A) Acclimate Plus detector is an
intelligent, addressable, multi-sensing, low-profile detector
designed for use with Notifier Notifier Onyx and CLIP series
Fire Alarm Control Panels (FACPs).

Features
• Automatically adjusts sensitivity levels without operator
intervention or programming. Sensitivity increases with
heat.
• Microprocessor-based, combination photo and thermal
technology.
• Compatible with all Notifier Onyx and CLIP series Fire
Alarm Control Panels (FACPs).
• Addressable-analog communication.
• Sleek, low-profile design.
• Two-wire SLC connection.
• Rotary, decimal addressing (1-99 on CLIP systems, 1-159
on FlashScan systems).
• Addresses can be viewed and changed without electronic
programmers.
• Dual bi-color LED design provides 360° viewing angle.
• LEDs lock red when in alarm. In FlashScan, LEDs flash
green in standby for normal condition.
• Built-in tamper-resistant feature.
• Constructed of off-white fire-resistant plastic, designed to
commercial standards, and offers an attractive appearance.
• SEMS screws for wiring of the separate base.
• Several base options, including relay, isolator, and sounder.
• Built-in functional test switch activated by external magnet.
• Listed to UL 268.
• Capable of heat-only alarm mode, enabled by a special
command from the panel. Smoke alarms are ignored.
• Low-temperature signal at 45°F +/– 10°F (7.22°C +/–
5.54°C)

Specifications
Sensitivity: auto-adjusting levels: 1 to 2%/ft. and 2 to 4%/ft.
with classic CLIP systems; 1 to 2, 2 to 3, and 3 to 4%/ft. with
systems; fixed-sensitivity levels: 1, 2, and 4%/ft. with classic
CLIP systems; 0.5, 1, 2, 3, and 4%/ft. with FlashScan
Operating temperature: 0°C to 38°C (32°F to 100°F).
UL-Listed velocity range: 0 – 4000 ft./min. (1219.2 m/min.),
suitable for installation in ducts.
Relative humidity: 10% – 93% noncondensing.
Thermal sensing rating: fixed-temperature setpoint 135°F
(57°C).