Drone Ja4cu F7 Flight Control OSD BEC 5V 8V Kontrol Dual Kamera

Ja4cu F7 Flight Control OSD BEC 5V 8V Kontrol Dual Kamera Deluxe untuk RC Drone JHEMCU F7 Flight Control OSD BEC 5V 8V Control Dual Camera Deluxe for RC DroneFeatures:1.Integrated OSD, built-in 5V/2A (internal power supply, receiver, LED, BUZZER, etc.), 8V/3A BEC (camera and picture transmission mode power supply, can be controlled by USER2 to turn it on and off), two independent BEC work separately , do not interfere with each other, optimized circuit design, high-performance hardware, further guarantee the powerful performance of the flight control. 2.Support two camera inputs (C1, C2 is the video input interface, controlled by USER1 switch, the default C1 is the input signal).3.The perfect interface definition, leaving the available interfaces.8P and 6P 1.0MM sockets are designed to facilitate direct input of the plug wire.4.Built-in 16MB of onboard memory, with 16kHz recording rate, record flight data, in order to support the 32K update frequency.5.The flight controller is deluxe version (Deluxe). Descriptions:1.JHEMCU Dual F7, using STM32F722RET6 high-performance processor, ICM2689+MPU6000 dual gyroscope, switching through CLI command, the default is ICM20689.Specifications:Model: JHEMCU Dual F7Main control chip: STM32F722RET6216MHzGyro: Dual ICM20689+MPU6000 dual gyroscope access (SPI)Barometer: BMP280 OSD chip: AT7456EBlack Box: 16MB LED programming: supportBB ring: supportInput voltage: 2-6SI2C interface: supportBEC-1: 5V/2A (internal power supply, receiver, LED, BUZZER, etc.)BEC-2: 8V/3A (camera and picture transmission mode power supply, can be controlled by USER2 to turn it on and off)Dual camera input: support (C1, C2 is the video input interface, controlled by USER1 switch, default C1 is the input signal)Serial control port: six channels (UART1, UART2, UART3, UART4, UART5, UART6)Flight Control Firmware: BetaflightTarget: JHEF7DUAL.HEXHole position and damping ball hole position conversion: 30.5*30.5mm, 4mmFlight control size: