32-bit ARM Cortex-M4 CPU Main microcontroller: Nordic Semiconductor nRF52833 Clock Speed: 64MHz Memory size: 512KB Flash RAM size: 128KB RAM USB Interface: NXP KL27Z with 32KB RAM 5x5 LED Matrix Display (Red LEDs) Two Programmable Buttons Touch Sensitive micro:bit logo Additional Power Indicator LED and Mic input indicator LED Built-in MEMS microphone input Onboard Accelerometer, Compass, Light and Temperature Sensors Wireless Communication, via Bluetooth 5.0 and BLE and 2.4GHz Radio Edge Connectors: Total 25 pins: 20 smaller pitch to pitch pins, 5 RINGS Notched Edge pins 4 Dedicated GPIO, PWM, I2C, SPI, Power and etc. 5 Ring pins for connecting crocodile clips or banana plugs 20-pin Edge Connectors, 5 notched edge Connectors Dedicated I2C bus for peripherals Power Button to power off the MCU Micro USB Type-B Connector JST-PH Battery Connector (Not JST-XH) Reset Button with Status LED Available current for external devices: 200mA Programming Platform: C++, Makecode, Python, Scratch Size: 5cm (w) x 4cm (h)
Packing list: 1 x micro:bit V2 Board (OPTIONAL SESUAI VARIAN PRODUK YANG DI PILIH) 1 x quickstart guide booklet (updated for micro:bit V2) 1 x box designed to be used in your first micro:bit project (Updated with cutting for micro:bit V2) 1 x 2xAA battery holder with ON/OFF switch 4 x PKCell AA battery 1 x USB micro B cable 1 x 3V micro servo motor 1 x Servo connector to male dupont pin extension wire 2 x 5mm yellow LED 2 x 5mm green LED 2 x 5mm red LED 6 x 100 ohm 0.25W resistor 3 x Quick wiring press type terminal block 10 x Crocodile clip with wire
Jika ada yang kendala atau keterangan yang kurang jelas, silahkan bertanya, kami akan memberikan solusi.