Arduino MKR1000 WIFI With Header - MKR 1000 Original Made In Italy

𝐍𝐎𝐓𝐄: 𝐓𝐈𝐃𝐀𝐊 𝐌𝐄𝐍𝐄𝐑𝐈𝐌𝐀 𝐊𝐋𝐀𝐈𝐌 𝐀𝐓𝐀𝐔 𝐊𝐎𝐌𝐏𝐋𝐀𝐈𝐍 𝐃𝐈 𝐋𝐔𝐀𝐑 𝐒𝐈𝐒𝐓𝐄𝐌 𝐓𝐎𝐊𝐎𝐏𝐄𝐃𝐈𝐀

SKU: KF3041
Code: ABX00011

Arduino MKR1000 specification:

MICROCONTROLLER = SAMD21 Cortex-M0+ 32bit low power ARM MCU
BOARD POWER SUPPLY (USB/VIN) = 5V
SUPPORTED BATTERY(*) = Li-Po single cell, 3.7V, 700mAh minimum
CIRCUIT OPERATING VOLTAGE = 3.3V
DIGITAL I/O PINS = 8
PWM PINS = 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 -or 19)
UART = 1
SPI = 1
I2C = 1
ANALOG INPUT PINS = 7 (ADC 8/10/12 bit)
ANALOG OUTPUT PINS = 1 (DAC 10 bit)
EXTERNAL INTERRUPTS = 8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 - or 17)
DC CURRENT PER I/O PIN = 7 mA
FLASH MEMORY = 256 KB
SRAM = 32 KB
EEPROM = no
CLOCK SPEED = 32.768 kHz (RTC), 48 MHz
LED_BUILTIN = 6
FULL-SPEED USB DEVICE AND EMBEDDED HOST
LENGTH = 61.5 mm
WIDTH = 25 mm
WEIGHT = 32 gr.

The MKR1000 Wifi module supports certificate SHA-256.

Warning: Unlike most Arduino & Genuino boards, the MKR1000 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.