ESP32 38PIN WROOM CP2102 2.4GHz Dual Core WIFI BT Development Board

𝐍𝐎𝐓𝐄: 𝐓𝐈𝐃𝐀𝐊 𝐌𝐄𝐍𝐄𝐑𝐈𝐌𝐀 𝐊𝐋𝐀𝐈𝐌 𝐀𝐓𝐀𝐔 𝐊𝐎𝐌𝐏𝐋𝐀𝐈𝐍 𝐃𝐈 𝐋𝐔𝐀𝐑 𝐒𝐈𝐒𝐓𝐄𝐌 𝐓𝐎𝐊𝐎𝐏𝐄𝐃𝐈𝐀

SKU: KK3007

This is an IoT board which can be used as a client mode where collected sensor data can be sent to the server using WiFi protocol. Or, used as the main server to control Led, relay or any output that connected to this board. This board is fully supported by the Arduino IDE program.


Specification:

Type: Wifi + Bluetooth module
Model: ESP32 38 pins
Power voltage (USB): 5V DC
Input/Output voltage: 3.3V DC
Power consumption: 5A in suspension mode
Main CPU: Tensilica Xtensa 32-bit LX6
Performance: Up to 600 DMIPS
Clock frequency: up to 240Mhz
Secondary processor: allows for basic operations in ultra low-consumption mode
Wifi: 802.11 b/g/n/e/i (802.11n @ 2.4 GHz up to 150 Mbit/s)
Bluetooth: 4.2 BR/EDR BLE dual control mode
Memory: 448 KByte ROM, 520 KByte SRAM, 6 KByte SRAM on RTC and QSPI supports multiple flash / SRAM chips
Chip USB-Serial: CP2102
Antenna: PCB
GPIO digital pins: 24 (some pins only as input)
Digital analog convessor: two 12bit SAR type ADC, supports measurements on up to 18 channels, some pins support an amplifier with programmable gain
Security: IEEE 802.11, including WFA, WPA/WPA2 and WAPI
Hardware-accelerated cryptography: AES, SHA-2, RSA, elliptical curve cryptography (ECC), random number generator (RNG)