LVD / Low Voltage Disconnect XH-M609 protect - LVD (12-36Volt)

Product parameters Product name: battery over-discharge protection module Power supply voltage: DC 12-36V Output voltage: equal to supply voltage Control accuracy: 0.1V Power consumption: lt;1.5W Scope of use: various storage batteries/lithium batteries Net weight: 28g Product size: 57*42*19mm above picture is a simple schematic diagram of the circuit board principle, the module controls the relay on and off to control the output. The operating voltage of the main board cannot be less than 7V, so the battery voltage must be ≥ 7V. When the battery supplies power to the module, the output voltage is always equal to the battery voltage when the relay is closed. stop when the setting is lower than 12.5V, and start when it is higher than 14V: set the protection value: press #34;+ #34; once to display the protection value, double-click #34;+ #34;, the decimal point flashes, press #34;+, - #34; to change the value at this time, change to 12.5. If there is no operation for 3 seconds, the module will automatically save and exit the setting mode. Set the hysteresis value: Press #34;- #34; once to display the hysteresis value, double-click #34;- #34;, the decimal point flashes, and press #34;+, - #34; to change the value to 1.5. If there is no operation for 3 seconds, the module will automatically save and exit the setting mode. Set to stop below 10V, start above 15.5V: set the protection value: press #34;+ #34; once to display the protection value, double-click #34;+ #34;, the decimal point flashes, press #34;+, - #34; to change the value at this time, change it to 12.5. If there is no operation for 3 seconds, the module will automatically save and exit the setting mode. Set the hysteresis value: Press #34;- #34; once to display the hysteresis value, double-click #34;- #34;, the decimal point flashes, and press #34;+, - #34; to change the value to 1.5. If there is no operation for 3 seconds, the module will automatically save and exit the setting mode. reset When the power is off, press and hold the two buttons at the same time, and then power