PROLINK PHN1102 Outdoor Wireless Bridge N300 CPE/AP

HARDWARE FEATURES Interface 1* 10/100Mbps Ethernet WAN Port (Passive PoE In) 1* 10/100Mbps Ethernet LAN Port 1* Reset Button 1* S(Slave)/M(Master) toggle switch Power Supply Passive Power over Ethernet through WAN Port, or DC Jack In (12V 1A) LED Indicator Power, LAN, WAN, Master/Slave, Wi-Fi Channel Antenna Type Built-in 12dBi High Performance Panel Antenna Beam Width: 60° Enclosure Outdoor IP65 Dust-tight Water-Resistant Protection WIRELESS FEATURES Wireless Standards IEEEE 802.11 b/g/n Frequency 2.4GHz N Data Rate Up to 300Mbps Transmit Power Up to 20dBm Note: maximum transmission power may vary across different countries subject to local regulatory and regions in which the device is used Transmission Distance Up to 2Km (in Wireless Bridge mode) * Multiple SSID Support Up to 4 Multiple SSID Physical Master/Slave Configuration Configurable through S(Slave)/M(Master) toggle switch in the device (only for Wireless Bridge/WDS mode) Wi-Fi Analyser Supported SOFTWARE FEATURES Wireless Configurations 2.4GHz a/an/ac modes Automatic / Static Channel Selection Security: WPA/WPA2, WPA-PSK/WPA2-PSK (AES/TKIP) Encryption SSID Broadcast Enable/Disable Multi-SSID Wireless MAC Address Filter Operation Mode Wireless Bridge/WDS, Gateway, Wi-Fi Repeater, Wireless AP WAN Connection Type Dynamic IP, Static IP, PPPoE Management Web-based http management (local / remote) Device discoverable through PROLiNK Wireless Controller (when WAN mode is set to get DHCP from AC) System Log System Tools Run-time Wireless Traffic Connection Rate Wireless Analyser Connected Clients information DIMENSION amp; WEIGHT Dimension 168 x 88 x 57.6 mm Weight 235g SYSTEM REQUIREMENTS OS Supported Microsoft Windows 7/10 MAC 10.6 and above Linux PACKAGE CONTENT Outdoor Wireless Bridge CPE/AP Ethernet Cable Quick Installation Guide 24V 0.5A Passive POE Injector Mounting Kit