Darkglass Microtubes X Bass Preamp Pedal

The Microtubes X multiband distortion engine brings into controls producers have been using for years in the studio, allowing you to separate and sculpt the portions of the spectrum that are distorted and remain untouched for ultimate flexibility.




Specifications


High-pass frequencyControls the cutoff frequency to be distorted, ranging from 100Hz (for thicker, fuzzier saturation) or 1kHz for ultra-sharp definition.
 
Low-pass frequencyControls the cutoff frequency to be mixed back to the high-pass side. Ranging from 50Hz (for only sub-bass) and 500Hz to preserve some clean mids.
 
LevelSets the overall output volume of the unit.
 
DriveSets the amount of distortion for the high pass side.
 
MixSets the blend between low-pass and high-pass signals.


MidsActive mid control placed after the Mix control. +-12dB @ 500Hz.
 
OutputConnect from the ¼” Output jack to the input of your amplifier or another effects pedal.
 
InputConnect your instrument or output from your pedal board to the ¼” mono jack.
 
9V DCOnly use a regulated 9V DC adapter with a center-negative plug.


DimensionsWidth: 75 mm / 3″
Length: 111 mm/ 4¼″
Height: 43 mm / 1¾″
Weight: 250 g / 0.55 lb
 
WarningThe Microtubes X has a current draw of 30mA. Only use a regulated 9V DC adapter with a center-negative plug.
Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.