Fluke CIQ 100 cableiq cable qualification tester CIQ-KIT CIQ-WM - CIQ-KIT

Cable IQ qualification tester Fluke CIQ100 Features and Benefits: • Test and troubleshoots all coax, data and voice wiring • Graphically maps wiring configuration and distance verification to faults with built-in TDR • Locates and traces cables with IntelliTone digital signalling technology • Software for professional test reports • Documents cabling systems are installed correctly and will perform reliably • Troubleshoots connectivity problems caused by insufficient bandwidth for voice, 10/100 VoIP or Gigabit Ethernet General Specifications Cable types supported UTP, STP, FTP, SSTP, RG6, RG59, audio and security Qualification autotests 1000BASE-T, 100BASE-TX, 10BASE-T, VoIP, 1394b S100, TELCO, Wiremap only, Coax Supported tests Wiremap, length, cable signal performance, digital toner, analog toner, Ethernet port detection and identification, analog telephone detection, blink port light, continuity, speaker test, cable fault finding, video signal detection. Wiremap Can detect single wire faults and supports MultiMap mode with up to seven remote office identifiers. Draws proportional wire length to breaks. Detects split pairs. Find fault Measures crosstalk and impedance and compares against appropriate limits based on qualification test selected. Detects location of large point sources as well as distributed sources in the cabling if they are sufficient to disqualify the application Results storage Up to 250 qualification test results Power Battery type: 4 AA (NEDA 15A, IEC LR6) alkaline batteries Battery life 20 hours of typical use, without backlight Other battery types supported 4AA photo lithium, NIHM, NICAD Dimensions and weight 7in x 3.5in x 1.75in (17.8cm x 8.9cm x 4.5cm) 1.2 lb (0.55 kg)