4.7/ 5.0
95% pembeli merasa puas
23 rating • 23 ulasan
5(17)73.91%
4(5)21.74%
3(0)0%
2(1)4.35%
1(0)0%
Atur jumlah dan catatan
Stok Total: 1000
Subtotal
Rp16.000
TP-4056 5V Micro USB 1A Lithium Battery Charging + Protection module
Rp16.000
Module Applications
This module is used for single-cell lithium or lithium multi-section parallel, charging ports can take power from USB.
Instructions / Precautions
Test current meter in series with the charge sheet only 5V input.
Charge current is best battery capacity 0.37C, is 0.37 times the capacity, such 1000mAH battery charging current 400 this is enough. The effect of excessive charging speed backward, rushed over battery voltage out on much!
Not too small and too long charging connector wires. Such big connection resistance. Too thin, then rushed over battery voltage out on much.
Connected to the battery the best good contact. Otherwise rushed over battery voltage out on much.
If the 5V input voltage is high, such as 5.2 or even 5.5, will result in insufficient charging current is 1000mA, this is normal. High voltage chip fever will automatically reduce the charging current, not to chip burned. Chip at work about 60 degrees fever is normal. After the charging current is large.
Enter the reverse has no effect on the chip, but the output (battery terminals) reverse will burn the chip, please note that buyers.
Related Product
https://www.tokopedia.com/mimpi-kaya/5v-micro-usb-1a-lithium-battery-charging-protection-in-one-board-module
This module is used for single-cell lithium or lithium multi-section parallel, charging ports can take power from USB.
Instructions / Precautions
Test current meter in series with the charge sheet only 5V input.
Charge current is best battery capacity 0.37C, is 0.37 times the capacity, such 1000mAH battery charging current 400 this is enough. The effect of excessive charging speed backward, rushed over battery voltage out on much!
Not too small and too long charging connector wires. Such big connection resistance. Too thin, then rushed over battery voltage out on much.
Connected to the battery the best good contact. Otherwise rushed over battery voltage out on much.
If the 5V input voltage is high, such as 5.2 or even 5.5, will result in insufficient charging current is 1000mA, this is normal. High voltage chip fever will automatically reduce the charging current, not to chip burned. Chip at work about 60 degrees fever is normal. After the charging current is large.
Enter the reverse has no effect on the chip, but the output (battery terminals) reverse will burn the chip, please note that buyers.
Related Product
https://www.tokopedia.com/mimpi-kaya/5v-micro-usb-1a-lithium-battery-charging-protection-in-one-board-module
Ada masalah dengan produk ini?