Holybro Pixhawk 4 Mini Autopilot Flight Controller M8N GPS Store 10B

Holybro Pixhawk 4 Mini Autopilot Flight Controller M8N GPS Store 10B Kami Menyediakan Berbagai Macam Barang yang Anda Butuhkan - Item Pre-Order (6 - 10 Hari). - Semua Produk Berkualitas. - Pengiriman Cepat (Tergantung Alamat Pengiriman). - Hubungi Kami Untuk Menanyakan Ketersediaan Barang. Happy Shopping ! Holybro Pixhawk 4 Mini Autopilot Flight Controller M8N GPS Module PM06 Power Management for RC Drone The Pixhawk 4 Mini autopilot is designed for engineers and hobbyists who are looking to tap into the power of Pixhawk 4 but are working with smaller drones. Pixhawk 4 Mini takes the FMU processor and memory resources from the Pixhawk 4 while eliminating interfaces that are normally unused. This allows the Pixhawk 4 Mini to be small enough to fit in a 250mm racer drone. Pixhawk 4 Mini was designed and developed in collaboration with Holybro and Auterion . It is based on the Pixhawk FMUv5 design standard and is optimized to run PX4 flight control software. Specification: Flight controller: Dimensions: 38x55x15.5mm Operating temperature: -40 ~ 85 c Main FMU Processor: STM32F765, 32 Bit Arm Cortex -M7, 216MHz, 2MB memory, 512KB RAM On-board sensors: -Accel/Gyro: ICM-20689 -Accel/Gyro: BMI055 -Magnetometer: IST8310 -Barometer: 10B5611 Interfaces: -8 PWM outputs -4 dedicated PWM/Capture inputs on FMU -Dedicated R/C input for CPPM -Dedicated R/C input for Spektrum / DSM and S.Bus with analog / PWM RSSI input -3 general purpose serial ports -2 I2C ports -3 SPI buses -1 CANBuses for CAN ESC -Analog inputs for voltage / current of battery -2 additional analog input Power System: Power Brick Input: 4.75~5.5V USB Power Input: 4.75~5.25V Servo Rail Input: 0~24V Max current sensing: 120A GPS: ublox S10BT-1387199